Search results
Results from the WOW.Com Content Network
A slide rule scale is a line with graduated markings inscribed along the length of a slide rule used for mathematical calculations. The earliest such device had a single logarithmic scale for performing multiplication and division, but soon an improved technique was developed which involved two such scales sliding alongside each other.
For example, aligning the rightmost 1 on the C scale with 2 on the LL2 scale, 3 on the C scale lines up with 8 on the LL3 scale. To extract a cube root using a slide rule with only C/D and A/B scales, align 1 on the B cursor with the base number on the A scale (taking care as always to distinguish between the lower and upper halves of the A scale).
Fuller calculator, Fuller-Bakewell model of 1928. The Fuller calculator, sometimes called Fuller's cylindrical slide rule, is a cylindrical slide rule with a helical main scale taking 50 turns around the cylinder. This creates an instrument of considerable precision – it is equivalent to a traditional slide rule 25.40 metres (1,000 inches) long.
4.2333 mm. The pica is a typographic unit of measure corresponding to approximately 1⁄6 of an inch, or from 1⁄68 to 1⁄73 of a foot. One pica is further divided into 12 points. In printing, three pica measures are used: The French pica of 12 Didot points (also called cicero) generally is: 12 × 0.376 = 4.512 mm (0.1776 in).
The calipers in the diagram show a primary reading on the metric scale of about 2.475 cm (2.4 cm read from the main scale plus about 0.075 cm from the vernier scale). Calipers often have a "zero point error": meaning that the calipers do not read 0.000 cm when the jaws are closed.
A variety of rulers A 2 m (6 ft 6 + 3 ⁄ 4 in) carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
An architect's scale. A scale ruler is a scaled, three-edged ruler which has six different scales marked to its sides. A typical combination for building details is 1:20, 1:50, 1:100, 1:25, 1:75 and 1:125. There are separate rulers for zoning work as well as for inch units. Today scale rulers are made of plastic, formerly they were made of ...
For example, a 7/8 violin has a scale of about 317 mm, a 3/4-size instrument a scale of 307 mm, a half-size one 287 mm, and a quarter-size one 267 mm. 1/8, 1/10, 1/16 and 1/32 and even 1/64 violins also exist, becoming progressively smaller, but again in no proportional relationship. (A full-size instrument is described as 4/4.)