Search results
Results from the WOW.Com Content Network
The limiting reagent (or limiting reactant or limiting agent) in a chemical reaction is a reactant that is totally consumed when the chemical reaction is completed. [ 1 ] [ 2 ] The amount of product formed is limited by this reagent, since the reaction cannot continue without it.
At high values of Δ f H, desorption becomes the rate-limiting step. The maximum rate, which is observed for the platinum group metals in this case, requires intermediate values of Δ f H, with the rate being a combination of the rate of adsorption and the rate of desorption. [3] Catalysts can exceed the Sabatier limit via catalytic resonance.
The identification of a factor as limiting is possible only in distinction to one or more other factors that are non-limiting. Disciplines differ in their use of the term as to whether they allow the simultaneous existence of more than one limiting factor (which may then be called "co-limiting"), but they all require the existence of at least one non-limiting factor when the terms are used.
To find the limiting reagent and the mass of HCl produced by the reaction, we change the above amounts by a factor of 90/324.41 and obtain the following amounts: 90.00 g FeCl 3, 28.37 g H 2 S, 57.67 g Fe 2 S 3, 60.69 g HCl. The limiting reactant (or reagent) is FeCl 3, since all 90.00 g of it is used up while only 28.37 g H 2 S are consumed.
The rate-determining step can also be the transport of reactants to where they can interact and form the product. This case is referred to as diffusion control and, in general, occurs when the formation of product from the activated complex is very rapid and thus the provision of the supply of reactants is rate-determining.
Conversion and its related terms yield and selectivity are important terms in chemical reaction engineering.They are described as ratios of how much of a reactant has reacted (X — conversion, normally between zero and one), how much of a desired product was formed (Y — yield, normally also between zero and one) and how much desired product was formed in ratio to the undesired product(s) (S ...
The stoichiometry of a chemical reaction is based on chemical formulas and equations that provide the quantitative relation between the number of moles of various products and reactants, including yields. [8] Stoichiometric equations are used to determine the limiting reagent or reactant—the reactant that is completely consumed in a reaction ...
The Curtin–Hammett principle is a principle in chemical kinetics proposed by David Yarrow Curtin and Louis Plack Hammett.It states that, for a reaction that has a pair of reactive intermediates or reactants that interconvert rapidly (as is usually the case for conformational isomers), each going irreversibly to a different product, the product ratio will depend both on the difference in ...