Search results
Results from the WOW.Com Content Network
The Utah model assigns different weight to different temperature bands; a full unit per hour is assigned only to temperatures between 3 °C (37 °F) and 9 °C (48 °F). Maximum effect is achieved at 7 °C (45 °F). [4] Temperatures between 13 °C (55 °F) and 16 °C (60 °F) (the threshold between chilling and warm weather) have zero weight ...
The first of the cooling load factors used in this method is the CLTD, or the Cooling Load Temperature Difference. This factor is used to represent the temperature difference between indoor and outdoor air with the inclusion of the heating effects of solar radiation. [1] [5] The second factor is the CLF, or the cooling load factor.
Growing degrees (GDs) is defined as the number of temperature degrees above a certain threshold base temperature, which varies among crop species. The base temperature is that temperature below which plant growth is zero. GDs are calculated each day as maximum temperature plus the minimum temperature divided by 2, minus the base temperature.
Cooling capacity is the measure of a cooling system's ability to remove heat. [1] It is equivalent to the heat supplied to the evaporator/boiler part of the refrigeration cycle and may be called the "rate of refrigeration" or "refrigeration capacity".
Fahrenheit Celsius Réaumur Temperature Absolute zero: 0 K 0 °Ra −459.67 °F −273.15 °C -218.52 °Ré Freezing point of brine [a] 255.37 K 459.67 °Ra 0 °F −17.78 °C −14.224 °Ré Freezing point of water [b] 273.15 K 491.67 °Ra 32 °F 0 °C 0 °Ré Boiling point of water [c] 373.1339 K 671.64102 °Ra 211.97102 °F 99.9839 °C
Plots of pressure vs temperature for three different gas samples extrapolated to absolute zero. The ideal gas law is based on observed empirical relationships between pressure (p), volume (V), and temperature (T), and was recognized long before the kinetic theory of gases was developed (see Boyle's and Charles's laws). The ideal gas law states ...
The volumetric heat capacity of solid materials at room temperatures and above varies widely, from about 1.2 MJ⋅K −1 ⋅m −3 (for example bismuth [3]) to 3.4 MJ⋅K −1 ⋅m −3 (for example iron [4]). This is mostly due to differences in the physical size of atoms.
Specific leaf area is a ratio indicating how much leaf area a plant builds with a given amount of leaf biomass: = where A is the area of a given leaf or all leaves of a plant, and M L is the dry mass of those leaves. Typical units are m 2 /kg or mm 2 /mg.