Search results
Results from the WOW.Com Content Network
Basalt fiber is made from a single material, crushed basalt, from a carefully chosen quarry source. [1] Basalt of high acidity (over 46% silica content [ 2 ] ) and low iron content is considered desirable for fiber production. [ 3 ]
Glass fiber (or glass fibre) is a material consisting of numerous extremely fine fibers of glass. Glassmakers throughout history have experimented with glass fibers, but mass manufacture of glass fiber was only made possible with the invention of finer machine tooling.
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
If you're using broadband (cable) internet and you can't connect, try the following troubleshooting steps in the order listed until you get up and running again. 1. Check if you can visit other sites with a different browser - If you can go to another site, the problem may be associated the browser you're using.
Hard-clad silica (HCS) or polymer-clad fiber (PCF) is an optical fiber with a core of silica glass (diameter: 200 μm) and an optical cladding made of special plastic (diameter: 230 μm). In contrast to all-silica fiber , the core and cladding can be separated from each other.
Fibre Channel (FC) is a high-speed data transfer protocol providing in-order, lossless [1] delivery of raw block data. [2] Fibre Channel is primarily used to connect computer data storage to servers [3] [4] in storage area networks (SAN) in commercial data centers.
Plastic optical fiber (POF) or polymer optical fiber is an optical fiber that is made out of polymer. Similar to glass optical fiber, POF transmits light (for illumination or data) through the core of the fiber. Its chief advantage over the glass product, other aspect being equal, is its robustness under bending and stretching.
OC-48 is also used as a transmission speed for tributaries from OC-192 nodes in order to optimize card slot utilization where lower speed deployments are used. Slower cards that drop to OC-12, OC-3 or STS-1 speeds are more commonly found on OC-48 terminals, where use of these cards on an OC-192 terminal would not allow for full use of the ...