Search results
Results from the WOW.Com Content Network
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
With a finished weight of 36 pounds (16 kg), the block weighs 51 pounds (23 kg) less than the cast-iron block in the Chevy II 153 cu in (2.5 L) inline-4. Plating the piston skirts was necessary to put a hard iron skirt surface opposite the silicon of the block to prevent scuffing. The plating was a four layer electro-plating process.
The castings for the XK block were manufactured for Jaguar by Leyland Motors.In 1968, Jaguar laid off 2,500 workers at both Radford and Brown Lane due to strike by Leyland workers over pay parity after the merger of Leyland with British Motor Holdings, which Jaguar estimated had cost them a loss of 160 cars a day at a cost of £320,000.
The LLV (also called Vortec 2900) is a 2.9 L; 178.3 cu in (2,921 cc) straight-4 DOHC engine produced between 2007 and 2012, with a 95.5 mm × 102 mm (3.76 in × 4.02 in) bore and a stroke. It replaced the LK5 and produced 185 hp (138 kW) at 5,600 rpm and 190 lb⋅ft (258 N⋅m) of torque at 2,800 rpm.
Compared to the FB20 engine, which is undersquare with an 84 mm × 90 mm (3.31 in × 3.54 in) bore and stroke for 2.0 L (1,995 cc) swept displacement, the FA20 is perfectly square with an 86 mm × 86 mm (3.39 in × 3.39 in) bore and stroke for 2.0 L (1,998 cc) swept displacement.
The 2.4 L (2,389 cc) KA24DE was used in many Nissan cars and trucks. Most KA24DEs bound for the US were built in the city of Aguascalientes, Mexico , with the exceptions of the 240SX, 1994-97 Altima (re-badged Bluebird SSS), and the U13 Bluebird released in Australia with FWD configuration, which were manufactured in Yokohama, Kanagawa , Japan ...
The 318-cubic-inch (5.2 L) 318 was released in 1950, replacing the 308. It shared the same 4 + 1 ⁄ 2 inches (110 mm) stroke as its predecessors but with a slightly larger 3 + 7 ⁄ 8 inches (98 mm) bore. It produced a maximum 136 hp @ 3400 rpm and 245 lb•ft @ 1400 rpm. [2] The 308 was discontinued in 1954 and replaced by the 324 cubic inch ...
The second-generation Cologne V6 was introduced in 1974. It displaced 2.8 L; 170.4 cu in (2,792 cc) with a bore and stroke of 93.03 mm × 68.5 mm (3.66 in × 2.70 in), and used a geared camshaft design. While based on the 2.6, the larger bore necessitated a different block. [2]