Search results
Results from the WOW.Com Content Network
In computing, a memory module or RAM stick is a printed circuit board on which memory integrated circuits are mounted. [ 1 ] Memory modules permit easy installation and replacement in electronic systems, especially computers such as personal computers , workstations , and servers .
A test with DDR and DDR2 RAM in 2005 found that average power consumption appeared to be of the order of 1–3 W per 512 MB module; this increases with clock rate and when in use rather than idling. [14] A manufacturer has produced calculators to estimate the power used by various types of RAM. [15]
The maximum random access memory (RAM) installed in any computer system is limited by hardware, software and economic factors. The hardware may have a limited number of address bus bits, limited by the processor package or design of the system. Some of the address space may be shared between RAM, peripherals, and read-only memory.
(For example, if a computer has 2 GB (1024 3 B) of RAM and a 1 GB page file, the operating system has 3 GB total memory available to it.) When the system runs low on physical memory, it can " swap " portions of RAM to the paging file to make room for new data, as well as to read previously swapped information back into RAM.
The HP Saturn processors, used in many Hewlett-Packard calculators between 1984 and 2003 (including the HP 48 series of scientific calculators) are "4-bit" (or hybrid 64-/4-bit) machines; as the Intel 4004 did, they string multiple 4-bit words together, e.g. to form a 20-bit memory address, and most of the registers are 64 bits wide, storing 16 ...
A memory rank is a set of DRAM chips connected to the same chip select, which are therefore accessed simultaneously.In practice all DRAM chips share all of the other command and control signals, and only the chip select pins for each rank are separate (the data pins are shared across ranks).
In a computer, the memory bank may be determined by the memory controller along with physical organization of the hardware memory slots. In a typical synchronous dynamic random-access memory (SDRAM) or double data rate SDRAM (DDR SDRAM), a bank consists of multiple rows and columns of storage units, and is usually spread out across several chips .
Computational RAM (C-RAM) is random-access memory with processing elements integrated on the same chip. This enables C-RAM to be used as a SIMD computer. It also can be used to more efficiently use memory bandwidth within a memory chip. The general technique of doing computations in memory is called Processing-In-Memory (PIM).