enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tire rotation - Wikipedia

   en.wikipedia.org/wiki/Tire_rotation

   [citation needed] If the tires are unidirectional, the rotation can only be rotated front to back on the same side of the vehicle to preserve the rotational direction of the tires, unless they are remounted. More complex rotation patterns are required if the vehicle has a full-size spare tire that is part of the rotation, or if there are snow ...

3. Slip (vehicle dynamics) - Wikipedia

   en.wikipedia.org/wiki/Slip_(vehicle_dynamics)

   In (automotive) vehicle dynamics, slip is the relative motion between a tire and the road surface it is moving on. This slip can be generated either by the tire's rotational speed being greater or less than the free-rolling speed (usually described as percent slip), or by the tire's plane of rotation being at an angle to its direction of motion (referred to as slip angle).

4. Tweel - Wikipedia

   en.wikipedia.org/wiki/Tweel

   The Tweel airless tire design. The Tweel (a portmanteau of tire and wheel) is an airless tire design developed by the French tire company Michelin.Its significant advantage over pneumatic tires is that the Tweel does not use a bladder full of compressed air, and therefore cannot burst, leak pressure, or become flat.

5. Tire - Wikipedia

   en.wikipedia.org/wiki/Tire

   Rotation: Tires may exhibit irregular wear patterns once installed on a vehicle and partially worn. Front-wheel drive vehicles tend to wear the front tires at a greater rate compared to the rear tires. Tire rotation is moving the tires to different car positions, such as front-to-rear, in order to even out the wear, with the objective of ...

6. Tire balance - Wikipedia

   en.wikipedia.org/wiki/Tire_balance

   If the tire is not checked, it has the potential to cause vibration in the suspension of the vehicle on which it is mounted. In tire retail shops, tire/wheel assemblies are checked on a spin-balancer, which determines the amount and angle of unbalance. Balance weights are then fitted to the outer and inner flanges of the wheel. [2]

7. Radial tire - Wikipedia

   en.wikipedia.org/wiki/Radial_tire

   A cross-section of a tire. Number 12 indicates the radial ply. Numbers 14 and 16 are bias plies. A radial tire (more properly, a radial-ply tire) is a particular design of vehicular tire. In this design, the cord plies are arranged at 90 degrees to the direction of travel, or radially (from the center of the tire).