Search results
Results from the WOW.Com Content Network
An actuator can be just a mechanism that is directly driven by the motions or forces of other parts of the system. An example is the camshafts that drive the intake and exhaust valves in internal combustion engines, driven by the engine itself. Another example is the mechanism that strikes the hours in a traditional grandfather clock or cuckoo ...
These include dc brush, dc brushless, stepper, or in some cases, even induction motors. It all depends on the application requirements and the loads the actuator is designed to move. For example, a linear actuator using an integral horsepower AC induction motor driving a lead screw can be used to operate a large valve in a refinery.
An example of loss of power is when the air compressor (the main source of compressed air that provides the fluid for the actuator to move) shuts down. If there is a spring inside of the actuator, it will force the valve open or closed and will keep it in that position while power is restored.
In HVAC control systems, actuators that control dampers and valves may be fail-safe, for example, to prevent coils from freezing or rooms from overheating. Older pneumatic actuators were inherently fail-safe because if the air pressure against the internal diaphragm failed, the built-in spring would push the actuator to its home position – of ...
A rack and pinion has roughly the same purpose as a worm gear with a rack replacing the gear, in that both convert torque to linear force. However the rack and pinion generally provides higher linear speed — since a full turn of the pinion displaces the rack by an amount equal to the pinion's pitch circle whereas a full rotation of the worm screw only displaces the rack by one tooth width.
Example of current loops used for sensing and control transmission. Specific example of a smart valve positioner used. Globe control valve with pneumatic diaphragm actuator and "smart" positioner which will also feed back to the controller the actual valve position. Taking the example of an air-operated valve, there are two control actions ...
The truth table defines how the controller reacts to detected faults, and the state chart defines how the controller switches between the different modes of operation (passive, active, standby, off, and isolated) of each actuator. For example, if a fault is detected in hydraulic system 1, then the truth table sends an event to the state chart ...
The aim of high redundancy actuation is not to produce man-made muscles, but to use the same principle of cooperation in technical actuators to provide intrinsic fault tolerance. To achieve this, a high number of small actuator elements are assembled in parallel and in series to form one actuator (see Series and parallel circuits).