enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Double bridle - Wikipedia

    en.wikipedia.org/wiki/Double_bridle

    A double bridle, also called a full bridle or Weymouth bridle, [1] is a bridle that has two bits and four reins (sometimes called "double reins"). One bit is the bradoon (or bridoon ), is a modified snaffle bit that is smaller in diameter and has smaller bit rings than a traditional snaffle, and it is adjusted so that it sits above and in front ...

  3. Gag bit - Wikipedia

    en.wikipedia.org/wiki/Gag_bit

    It has one ring on the upper shank, to attach the cheekpiece of the bridle. There is a lower shank, for the gag rein, and a middle loop to which it is possible to attach a snaffle rein. The mouthpiece has the ability to slide up the curved sides of the bit as the reins are taken up, putting pressure on the corners of the mouth and encouraging ...

  4. Tandem rolling mill - Wikipedia

    en.wikipedia.org/wiki/Tandem_rolling_mill

    and the tension across the second bridle will be (2.01.4142) T 1 = 0.5858 T 1 And so, the second bridle requires just over 40% more motor power compared to the first. If one wishes to reduce the number of spares; then it is desirable to have motors of the same power.

  5. Curb bit - Wikipedia

    en.wikipedia.org/wiki/Curb_bit

    A curb bit works on several parts of a horse's head and mouth. The bit mouthpiece acts on the bars, tongue and roof of the mouth. The shanks add leverage and place pressure on the poll via the crownpiece of the bridle, to the chin groove via the curb chain, and, especially with a "loose jaw" shank, may act on the sides of the mouth and jaw.

  6. Snaffle bit - Wikipedia

    en.wikipedia.org/wiki/Snaffle_bit

    Jointed mouthpiece: applies pressure to the tongue, lips, and bars with a "nutcracker" action. This is the most common mouthpiece found on a snaffle. [1]: 55 Straight mouthpiece: A straight bar with no curve. Several bit designs use a straight bar where the bit can be flipped over, thus using either the smooth bar side or a twisted bar.

  7. Bridle joint - Wikipedia

    en.wikipedia.org/wiki/Bridle_joint

    Corner bridle joint T-bridle joint. A bridle joint is a woodworking joint, similar to a mortise and tenon, in that a tenon is cut on the end of one member and a mortise is cut into the other to accept it. [1] The distinguishing feature is that the tenon and the mortise are cut to the full width of the tenon member.

  8. Bit shank - Wikipedia

    en.wikipedia.org/wiki/Bit_shank

    Some shanks may also add rings or slots to attach a snaffle rein at the mouthpiece, allowing the bit to be used with two sets of reins, making it a pelham bit. Some shanks, especially on the Weymouth, have small rings placed midway down the shank to attach a lip strap, a helpful addition to the bit for preventing a horse from grabbing at the ...

  9. Bridle - Wikipedia

    en.wikipedia.org/wiki/Bridle

    A bridle is a piece of equipment used to direct a horse. As defined in the Oxford English Dictionary, the "bridle" includes both the headstall that holds a bit that goes in the mouth of a horse, and the reins that are attached to the bit. It provides additional control and communication through rein pressure (Oxford English Dictionary, n.d ...