enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flange nut - Wikipedia

   en.wikipedia.org/wiki/Flange_nut

   A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.

3. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   The cage has two wings that when compressed allow the cage to be inserted into the square holes Clip-on nut: J-nut or U-nut, sheet metal nut, speed nut (ambiguously) Designed to be clipped to sheet metal Coupling nut: Extension nut A threaded fastener for joining two male threads, most commonly a threaded rod,[1][2] but also pipes Flange nut ...

4. Split beam nut - Wikipedia

   en.wikipedia.org/wiki/Split_beam_nut

   A split beam nut, also known as a split hex nut [1] or slotted beam nut, [2] is a locknut with slots cut in the top that separate the outside end into two [3] or more sections that are bent slightly inward, making the thread diameter undersized in the slotted portion.

5. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole ...

6. Furniture screw - Wikipedia

   en.wikipedia.org/wiki/Furniture_screw

   Insert nut, a type of en type of threaded insert for wood; Sex bolt, a type of nut with a low shoulder (flange) to provide resistance with little protrusion; T-nut, a nut that can be knocked into the back of a wood plate to provide a screw mounting hole; Wood hanger screw, a screw with machine threads in one end, and wood screw threads in the other

7. Bolted joint - Wikipedia

   en.wikipedia.org/wiki/Bolted_joint

   Holes are drilled in nuts and bolt heads, and wire is threaded through the holes to prevent back-rotation. This method of locking is labor intensive, but is still used on critical joints. [1] Locknuts Some portion of the nut deforms elastically during tightening to provide a locking action. Spring washers and lock washers