enow.com Web Search

  1. Ads

    related to: dexter leaf spring bushings by dimensions

Search results

  1. Results from the WOW.Com Content Network
  2. Leaf spring - Wikipedia

    en.wikipedia.org/wiki/Leaf_spring

    Originally called a laminated or carriage spring, and sometimes referred to as a semi-elliptical spring, elliptical spring, or cart spring, it is one of the oldest forms of vehicle suspension. A leaf spring is one or more narrow, arc-shaped, thin plates that are attached to the axle and chassis in a way that allows the leaf spring to flex ...

  3. Torque tube - Wikipedia

    en.wikipedia.org/wiki/Torque_tube

    Before 1937, Buicks used leaf springs, so the panhard rod was not used, though the torque tube allowed a cantilever spring suspension, which gives a softer ride than a center-mount axle on the leaf spring, as required by the Hotchkiss setup. In addition to transmitting traction forces, the torque tube is hollow and contains the rotating driveshaft.

  4. Torsion bar suspension - Wikipedia

    en.wikipedia.org/wiki/Torsion_bar_suspension

    The first vehicle to use torsion bars was Leyland Eight designed by J. G. Parry-Thomas and produced from 1920 to 1923, however its rear suspension, patented in 1919, [1] was retrospectively named "torsion bar assisted" by Leyland in a 1966 publication [2] because the bars only complemented the leaf springs.

  5. Trailing-arm suspension - Wikipedia

    en.wikipedia.org/wiki/Trailing-arm_suspension

    A trailing-arm suspension, also referred to as trailing-link, is a form of vehicle suspension.In a motor vehicle it places one or more horizontal arms (or "links") perpendicular to and forward of the axle on the chassis or unibody, which are connected to the axle or wheels with pivot joint(s).

  6. Double wishbone suspension - Wikipedia

    en.wikipedia.org/wiki/Double_wishbone_suspension

    In many racing cars, the springs and dampers are relocated inside the bodywork. The suspension uses a bellcrank to transfer the forces at the knuckle end of the suspension to the internal spring and damper. This is then known as a "push rod" if bump travel "pushes" on the rod (and subsequently the rod must be joined to the bottom of the upright ...

  7. Jaguar independent rear suspension - Wikipedia

    en.wikipedia.org/wiki/Jaguar_independent_rear...

    The pivot bearings at each end of the lower link are widely spaced so as to provide maximum longitudinal rigidity. Suspension is provided by two coil spring and damper units (yellow) on each side of the differential casing (four in total), the spring and damper units attaching to the crossbeam at the top and the lower link at the bottom.

  1. Ads

    related to: dexter leaf spring bushings by dimensions