enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Bored cylindrical lock - Wikipedia

    en.wikipedia.org/wiki/Bored_cylindrical_lock

    Some commercially-sold doors may come prepared to receive one or more bored cylindrical locks, such as entry doors, which typically require both a door knob and dead bolt. [ 2 ] In the United States, typically, the face bore is sized from 1.5 to 2.125 inches (3.81 to 5.40 cm) in diameter and is centered at 2.375 or 2.75 inches (6.03 or 6.99 cm ...

  3. Builders hardware - Wikipedia

    en.wikipedia.org/wiki/Builders_hardware

    Builders' hardware or just builders hardware is a group of metal hardware specifically used for protection, decoration, and convenience in buildings. [1] Building products do not make any part of a building, rather they support them and make them work. [2] It usually supports fixtures like windows, doors, and cabinets.

  4. Deadbolt - Wikipedia

    en.wikipedia.org/wiki/Deadbolt

    Door with two locks, one in the doorknob and a separate deadbolt. A deadbolt or deadlock is a type of lock morticed into a wooden door where a bolt is thrown into the door frame, using a key from either side, to secure the door. [1] It is distinct from a spring bolt lock because a deadbolt can only

  5. Glossary of locksmithing terms - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_locksmithing_terms

    Some strike plates have their hole size and placement calculated so a spring-bolt extends into the hole, but an adjacent anti-retraction device remains depressed, preventing the bolt from being retracted unless the lock is turned. Talon The part of the bolt of a lock upon which the key presses as it is turned. [11] Thermal relocking device

  6. List of screw and bolt types - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_and_bolt_types

    Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.

  7. Lockset - Wikipedia

    en.wikipedia.org/wiki/Lockset

    Metal fire-resistance rated door with a lockset consisting of a locking latch bolt operated by lever handle with an escutcheon that encompasses the locking mechanism.. A lockset (alternatively lock set) is the hardware and components that make up the locking or latching mechanism that can usually be found on a door or other hinged object but can also include sliding doors and dividers. [1]

  8. Pin tumbler lock - Wikipedia

    en.wikipedia.org/wiki/Pin_tumbler_lock

    The first known example of a tumbler lock was found in the ruins of the Palace of Khorsabad built by king Sargon II (721–705 BC.) in Iraq. [1] Basic principles of the pin tumbler lock may date as far back as 2000 BC in Egypt; the lock consisted of a wooden post affixed to the door and a horizontal bolt that slid into the post.

  9. Door lock - Wikipedia

    en.wikipedia.org/wiki/Door_Lock

    a deadbolt lock; a door chain; a locking door handle; an electromagnetic lock, which holds a door shut when electricity is supplied to it; a keycard lock, commonly used on hotel doors; a mortise lock, a lock installed in a hollowed-out pocket within a door; a rim lock, a lock fixed to the exterior of the door