Search results
Results from the WOW.Com Content Network
Repair and restoration of vintage amateur radio equipment may involve replacing vacuum tubes, reforming electrolytic capacitors if needed, replacing any faulty resistors, replacing two-wire power cords with three-wire cords except on transformerless AC/DC radios, and receiver alignment as necessary.
A simple crystal radio with no tuned circuit can be used to listen to strong AM broadcast signals. An early form of envelope detector was the crystal detector, which was used in the crystal set radio receiver. A later version using a crystal diode is still used in crystal radio sets today.
Block diagram of a crystal radio receiver Circuit diagram of a simple crystal radio. A crystal radio can be thought of as a radio receiver reduced to its essentials. [3] [39] It consists of at least these components: [22] [40] [41] An antenna in which electric currents are induced by electromagnetic radiation.
Reballing involves dismantling, heating the chip until it can be removed from the board, typically with a hot-air gun and vacuum pickup tool, removing the device, removing solder remaining on the device and board, putting new solder balls in place, replacing the original device if there was a poor connection, or using a new one, and heating the ...
A drawing of the MK484. The MK484 AM radio IC is a fully functional AM radio detector on a chip. It is constructed in a TO-92 case, resembling a small transistor.It replaces the similar ZN414 AM radio IC from the 1970s.
Marantz 2050L AM/FM stereo tuner (USA; 1978-1980) [1]. In electronics and radio, a tuner is a type of receiver subsystem that receives RF transmissions, such as AM or FM broadcasts, and converts the selected carrier frequency into a form suitable for further processing or output, such as to an amplifier or loudspeaker.
[20] [9] In an AM receiver, the amplitude of the audio signal from the detector, and the sound volume, is proportional to the amplitude of the radio signal, so fading causes variations in the volume. In addition as the receiver is tuned between strong and weak stations, the volume of the sound from the speaker would vary drastically.
In the case of AM, φ(t) (the phase component of the signal) is constant and can be ignored. In AM, the carrier frequency is also constant. Thus, all the information in the AM signal is in R(t). R(t) is called the envelope of the signal. Hence an AM signal is given by the function