Search results
Results from the WOW.Com Content Network
If the user does not provide valid credentials or if the authentication fails, a 403 status code is returned. IP restrictions: The server may also restrict access to specific IP addresses or IP ranges. If the user's IP address is not included in the list of permitted addresses, a 403 status code is returned.
As the HTTP/1.0 standard did not define any 1xx status codes, servers must not [note 1] send a 1xx response to an HTTP/1.0 compliant client except under experimental conditions. 100 Continue The server has received the request headers and the client should proceed to send the request body (in the case of a request for which a body needs to be ...
802.1X-2001 defines two logical port entities for an authenticated port—the "controlled port" and the "uncontrolled port". The controlled port is manipulated by the 802.1X PAE (Port Access Entity) to allow (in the authorized state) or prevent (in the unauthorized state) network traffic ingress and egress to/from the controlled port.
This is a list of Simple Mail Transfer Protocol (SMTP) response status codes. Status codes are issued by a server in response to a client's request made to the server. Unless otherwise stated, all status codes described here is part of the current SMTP standard, RFC 5321. The message phrases shown are typical, but any human-readable alternative ...
If you don't have broadband, you'll need to try other steps to fix problems with a dial-up internet connection. An active internet connection is required to be able to access all the best that AOL offers.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
Failed security check. 536: Data protection level not supported by security mechanism. 537: Command protection level not supported by security mechanism. 550: Requested action not taken. File unavailable (e.g., file not found, no access). 551: Requested action aborted. Page type unknown. 552: Requested file action aborted.
RFC 1122 refers to 0.0.0.0 using the notation {0,0}. It prohibits this as a destination address in IPv4 and only allows it as a source address under specific circumstances. A host may use 0.0.0.0 as its own source address in IP when it has not yet been assigned an address, such as when sending the initial DHCPDISCOVER packet when using DHCP .