Search results
Results from the WOW.Com Content Network
A hollow structural section (HSS) is a type of metal profile with a hollow cross section. The term is used predominantly in the United States, or other countries which follow US construction or engineering terminology. HSS members can be circular, square, or rectangular sections, although other shapes such as elliptical are also available.
Cross section diagram of standard strut channel. Basic strut channel comes in the open box section 1 + 5 ⁄ 8 in (41 mm) square. A half height 1 + 5 ⁄ 8 in × 13 ⁄ 16 in (41 mm × 21 mm) version is also available, used mostly where mounted directly to a wall as it has significantly less stiffness and ability to carry loads across an open space or brace.
EN10219-1 specifies the technical delivery conditions for cold formed welded structural hollow sections of circular, square or rectangular forms and applies to structural hollow sections formed cold without subsequent heat treatment. Requirements for S275JOH pipe tolerances, dimensions and sectional s275 pipe properties are contained in EN 10219-2.
Common sizes of corrugated material can range from a very thin 30 gauge (0.012 inches, 0.3 mm) to a relatively thick 6 gauge (0.1943 inches, 5 mm). Thicker or thinner gauges may also be produced. Thicker or thinner gauges may also be produced.
It typically begins with a large coil of sheet metal, between 1 inch (2.5 cm) and 20 inches (51 cm) in width, and 0.004 inches (0.10 mm) and 0.125 inches (3.2 mm) thick, supported on an uncoiler. The strip is fed through an entry guide to properly align the material as it passes through the rolls of the mill, each set of rolls forming a bend ...
The dimensions of these beams are classified as per IS:808 (as per BIS). [ citation needed ] In the United Kingdom , these steel sections are commonly specified with a code consisting of the major dimension, usually the depth, -x-the minor dimension-x-the mass per metre-ending with the section type, all measurements being metric.
The depth of the bearing seat at the ends of underslung LH- and DLH-Series Joists have been established at 5 inches (130 mm) for chord section number 2 through 17. A bearing seat depth of 7 + 1 ⁄ 2 inches (190 mm) has been established for the DLH Series chord section number 18 through 25.
This type of mesh is a square grid of uniformly placed wires, welded at all intersections, and meeting the requirements of ASTM A185 and A497 or other standards. [1] The sizes are specified by combining the spacing, in inches or mm, and the wire cross section area in hundredths of square inches or mm2. The common sizes are in the following table: