Search results
Results from the WOW.Com Content Network
In the power systems analysis field of electrical engineering, a per-unit system is the expression of system quantities as fractions of a defined base unit quantity. . Calculations are simplified because quantities expressed as per-unit do not change when they are referred from one side of a transformer to t
Its schematic can be seen in figure 1. It is an inverting converter, so the output voltage is negative with respect to the input voltage. The main advantage of this converter is the continuous currents at the input and output of the converter. The main disadvantage is the high current stress on the switch. [4] Fig. 1: Cuk converter circuit diagram.
A boost converter or step-up converter is a DC-to-DC converter that increases voltage, while decreasing current, from its input to its output . It is a class of switched-mode power supply (SMPS) containing at least two semiconductors, a diode and a transistor , and at least one energy storage element: a capacitor , inductor , or the two in ...
This is a switched-mode power supply with a similar circuit configuration to the boost converter and the buck converter. The output voltage is adjustable based on the duty cycle of the switching transistor. One possible drawback of this converter is that the switch does not have a terminal at ground; this complicates the driving circuitry.
A buck converter or step-down converter is a DC-to-DC converter which decreases voltage, while increasing current, from its input to its output . It is a class of switched-mode power supply . Switching converters (such as buck converters) provide much greater power efficiency as DC-to-DC converters than linear regulators , which are simpler ...
] Because capacitor C1 blocks direct current (DC), the average current through it (I C1) is zero, making inductor L2 the only source of DC load current. Therefore, the average current through inductor L2 (I L2) is the same as the average load current and hence independent of the input voltage. Looking at average voltages, the following can be ...
In electrical engineering, power conversion is the process of converting electric energy from one form to another. A power converter is an electrical device for converting electrical energy between alternating current (AC) and direct current (DC). It can also change the voltage or frequency of the current.
The neutral current can be determined by adding the three phase currents together as complex numbers and then converting from rectangular to polar co-ordinates. If the three-phase root mean square (RMS) currents are I L 1 {\displaystyle I_{L1}} , I L 2 {\displaystyle I_{L2}} , and I L 3 {\displaystyle I_{L3}} , the neutral RMS current is: