Ads
related to: 400mm wire draw pull out tool for sale
Search results
Results from the WOW.Com Content Network
A fish tape (also called a draw wire, draw tape, or an electrician ' s snake) is a tool used by electricians to route new wiring through walls and electrical conduit. [1]Made of a narrow band of spring steel, by careful manipulation, the tape can be guided through confined spaces such as wall cavities or conduits in many countries.
A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians. It is used for inserting wire into insulation-displacement connectors on punch down blocks , patch panels , keystone modules , and surface mount boxes (also known as ...
A towing sock or wire rope puller or wire pulling grip is a device that connects to the end of a cable, such as a power cable, in order to pull it through a tube or tunnel. [1] It works by tightening around the cable when pulled, in the same manner as a Chinese finger trap . [ 2 ]
A laser wire stripper is a computer-controlled machine, much like a CNC router, which uses a laser to burn off the insulation of the wire. Laser wire stripping machines are used mostly for very fine gauge wires since they do not damage the conductor.
Wire drawing is a metalworking process used to reduce the cross-section of a wire by pulling the wire through one or more dies. There are many applications for wire drawing, including electrical wiring, cables, tension-loaded structural components, springs, paper clips, spokes for wheels, and stringed musical instruments.
One of the most significant events in the firm's history was the recruitment in 1850 of George Bedson (1820-1884), a wire drawer who had previously been working for his father. Bedson eventually became responsible for production, making many important technical developments including a system of continuous rolling of wire rods “another of the ...
The drawbar pull is an important component that allows the milling machine to keep the tool in place while it’s being used. The force from the drawbar pull supplied to the tool has to be just right because not enough force would cause the tool to wobble leading to inaccuracy, and too much force would apply excessive stress, leading to shorter tool life.
A non-grounded device may be two-pole, two-wire; three-pole, three-wire; etc. [citation needed] The numerals following the hyphen is the current rating of the device in amperes. This number is followed by the letter 'R' to indicate a receptacle (socket) or 'P' to indicate a plug (prongs).
Ads
related to: 400mm wire draw pull out tool for sale