Search results
Results from the WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
Diesel engine : NMHC catalyst, NOx reduction catalyst, NOx absorber Particulate matter filter, Exhaust gas sensor, EGR system, VVT system, Boost pressure control, Fuel system. See OBD-II PIDs#Service_09 for an extensive list. Service / Mode $0A lists emission-related "permanent" diagnostic trouble codes stored. As per CARB, any diagnostic ...
It weighs 133 pounds without transmission fluid. [ 1 ] The 4L60E family of transmissions use 2 shift solenoids, initially called Shift Solenoid A & Shift Solenoid B, later changed to comply with OBD II (On Board Diagnostics revision 2) regulations to 1-2 Shift Solenoid & 2-3 Shift solenoid.
A group of tell-tales showing lights for "brake fluid", "stop lamp" and "check engine" Graphical tell-talesA tell-tale, sometimes called an idiot light [1] or warning light, is an indicator of malfunction or operation of a system, indicated by a binary (on/off) illuminated light, symbol or text legend.
In a collision in which two young women in a Chevrolet Cobalt were killed when the ignition switch shut off the engine, GM only counted the death of the woman in the front seat, because the death of the woman in the back seat was not caused by the failure of the airbag to deploy. [16] Most of the victims were under age 25. [17]
The "MN4" 4T40E is able to handle vehicles up to 4000 lb (1814 kg) GVWR. The final drive ratio can vary depending on the car's curb weight and engine power output. 3.91, 3.63, 3.29, 3.05, 3.69, and 3.42 are all of the available ratios used in the 4T40 (and 4T45) transmission; Made possible by using combinations selected from 3 different sprocket combinations (32/38, 35/35, 33/37) and 2 ...
This was a later model of the 125 that debuted for 1982 and included a torque converter clutch or TCC. The TCC acts similar to a clutch in a manual transmission vehicle, in that at speeds above 35 MPH a combination of engine vacuum- and temperature-sensing valves, and a dedicated brake switch - and in later models an ECU - activated a solenoid which engaged a clutch physically locking the ...
The TPS sensor along with the vehicle speed sensor are the two main inputs for most TCUs. Older transmissions use this to determine engine load, with the introduction of drive-by-wire technology, this is often a shared input between the ECU and TCU. The input is used to determine the optimum time and characteristics for a gear change according ...