enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Street elbow - Wikipedia

   en.wikipedia.org/wiki/Street_elbow

   Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.

3. Process duct work - Wikipedia

   en.wikipedia.org/wiki/Process_Duct_Work

   Therefore, minimizing duct pressure drop by minimizing turbulence at elbows and transitions is of importance. Duct elbow radius is usually 1 1/2 to 2 times the duct size. The side slopes of transitions are typically 10 to 30 degrees. Note: the duct gas velocity is chosen to minimize duct dust dropout.

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   The key point is that the plumbing term focuses on the degree of bend from the original straight pipe, not the resulting angle. Elbows are also categorized by length. The radius of curvature of a long-radius (LR) elbow is 1.5 times the pipe diameter, but a short-radius (SR) elbow has a radius equal to the pipe diameter. Wide available short ...

5. Duct (flow) - Wikipedia

   en.wikipedia.org/wiki/Duct_(flow)

   Round duct is made using a continuous spiral forming machine which can make round duct in nearly any diameter when using the right forming die and to any length to suit, but the most common stock sizes range evenly from 4" to 24" (10-60 cm) with 6"-12" (15-30 cm) being most commonly used. Stock pipe is usually sold in 10' (300 cm) joints.

6. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   Pipe is usually delivered to a customer or jobsite as either "sticks" or lengths of pipe (typically 20 feet (6.1 m), called single random length) or they are prefabricated with elbows, tees and valves into a prefabricated pipe spool [A pipe spool is a piece of pre-assembled pipe and fittings, usually prepared in a shop so that installation on ...

7. Electrical conduit - Wikipedia

   en.wikipedia.org/wiki/Electrical_conduit

   Fittings for non-threaded conduits are either secured with set screws or with a compression nut that encircles the conduit. Fittings for general purpose use with metal conduits may be made of die-cast zinc, but where stronger fittings are needed, they are made of copper-free aluminum or cast iron. Couplings connect two pieces of conduit together.