Search results
Results from the WOW.Com Content Network
Ramset 342 Dyna Drill and Chipping Hammer, shown with chipping chisel. A rotary hammer, also called rotary hammer drill [1] is a power tool that can perform heavy-duty tasks such as drilling and chiseling hard materials. [2] It is similar to a hammer drill in that it also pounds the drill bit in and out while it is spinning. However, rotary ...
An electropneumatic hammer is often called a rotary hammer because it has an electric motor, which rotates a crank. The hammer has two pistons – a drive piston and a free-flight piston. The crank moves the drive piston back and forth in the same cylinder as the flight piston. The drive piston never touches the flight piston.
DeWalt Ford Fusion in 2008, driven by Matt Kenseth. DeWalt Tools sponsored NASCAR driver Matt Kenseth from 1999 through to the season of 2009. In this time period, Kenseth won 18 races, the 2000 Sprint Cup Rookie of the Year Award, 2003 Winston Cup Series Championship, 2004 NEXTEL Cup All Star Race and the 2009 Daytona 500.
German company Bosch produced the first "Bosch-Hammer" around 1932 in mass production. The US company Milwaukee Electric Tool Corporation states that in 1935, it was selling a lightweight 1 ⁄ 4 in (6.4 mm) electric hammer drill (cam-action). [15] Hand-cranked percussion drills were made in the UK in the mid-twentieth century. [16]
A permanent magnet motor is a type of electric motor that uses permanent magnets for the field excitation and a wound armature. The permanent magnets can either be stationary or rotating; interior or exterior to the armature for a radial flux machine or layered with the armature for an axial flux topology.
A motor soft starter is a device used with AC electrical motors to temporarily reduce the load and torque in the powertrain and electric current surge of the motor during start-up. This reduces the mechanical stress on the motor and shaft, as well as the electrodynamic stresses on the attached power cables and electrical distribution network ...
The largest machines used in wood processing, often called "tub or horizontal grinders", may handle a material diameter of 2.4 m (8 ft) or greater, and use carbide-tipped flail hammers to pulverize wood rather than cut it, producing a shredded wood rather than chip or chunk. These machines usually have a power of 150–750 kW (200–1,000 hp).
Concrete spun pile driving using diesel hammer in Patimban Deep Sea Port, Indonesia. A modern diesel pile hammer is a large two-stroke diesel engine. The weight is the piston, and the apparatus which connects to the top of the pile is the cylinder. Piledriving is started by raising the weight; usually a cable from the crane holding the pile ...