Search results
Results from the WOW.Com Content Network
Many modern engines automatically activate the glowplugs when the operator unlocks the vehicle or opens the door to the car, thus simplifying the process and shortening the waiting time the operator has to wait before the engine will start. In addition, the time needed to pre-heat the engine is typically 6-8 seconds. [2]
Gasoline is brought to the heater from the vehicle's fuel system. A fan blows air into a combustion chamber, where a glow plug or similar ignition device lights the gasoline/air mixture. Ducting around this contains a second fan, which blows air warmed by contact with the combustion chamber into the interior of the vehicle.
As batteries became more common in cars (due to the increased usage of electric starter motors), magneto systems were replaced by systems using an induction coil.The 1886 Benz Patent-Motorwagen and the 1908 Ford Model T used a trembler coil ignition system, whereby the trembler interrupted the current through the coil and caused a rapid series of sparks during each firing.
The energy used to heat the engine adds a cost. However, the savings in fuel generally outweigh this cost, especially if a timer is used to limit the heating period to about 4 hours before the expected start time. Taking the needed precautions, a kerosene jet-heater can also be used to pre-heat the engine. [2]
The engine compression is higher as the lack of heat makes ignition more difficult. Low temperatures cause engine oil to become more viscous, making it more difficult to circulate the oil. Air becomes more dense the cooler it is. This affects the air-fuel ratio, which in turn affects the flammability of the mixture.
An electric starter with sufficient power to turn a large diesel engine would itself be so large as to be impractical so there is a need for an alternative system. An air start system has three main components along with various safety components, namely the air start injector, the distributor and the air receivers. When the system is initiated ...
The emergency stop signal is automatically activated if the vehicle speed is greater than 50 km/h (31 mph) and the emergency braking logic defined by regulation No. 13 (heavy vehicles), 13H (light vehicles), or 78 (motorcycles) is activated; the ESS may be displayed when a light vehicle's deceleration is greater than 6 m/s 2 (20 ft/s 2) or a ...
The light normally appears when the vehicle ignition is turned on, but the engine is not running, as it detects no oil pressure due to the oil pump not operating (the oil pump is powered off the crankshaft, so only operates when the engine is running). It normally turns off a few seconds after engine start as the oil pump starts working and ...