Search results
Results from the WOW.Com Content Network
RS-485, also known as TIA-485(-A) or EIA-485, is a standard, originally introduced in 1983, defining the electrical characteristics of drivers and receivers for use in serial communications systems. Electrical signaling is balanced , and multipoint systems are supported.
An 8 pin circular connector is used to connect (or daisy chain) AISG devices. AISG consortium has released C485 standard for this RS-485 connector. This standard specifies the mechanical dimensions of the connector more tightly than the previously used standard (IEC 60130-9 - Ed. 3.0 standard with screw-ring locking ring).
The number gives their outer screw thread diameter in millimeters as with the identically named screws. However, the connectors are further classified by a so-called coding, denoted by one or more letters, which defines things like pin layout, shape of connecting surfaces and electrical properties. [2] [3]
The serial DCD pin can be used to accurately detect a PPS signal, as described in RFC 2783: [1] One convenient means to provide a PPS signal to a computer system is to connect that signal to a modem-control pin on a serial-line interface to the computer. The Data Carrier Detect (DCD) pin is frequently used for this purpose.
SPI timing diagram for both clock polarities and phases. Data bits output on blue lines if CPHA=0, or on red lines if CPHA=1, and sample on opposite-colored lines. Numbers identify data bits. Z indicates high impedance. The SPI timing diagram shown is further described below: CPOL represents the polarity of the clock.
The height of the plug's insertion area is 0.260 inches (6.60 mm) and the contacts are 0.040 inches (1.02 mm) apart (contact pitch), so the width is dependent on the number of pin positions. [ 7 ] [ 8 ] However, not all plugs from all manufacturers have this capability, and some jack manufacturers warn that their jacks are not designed to ...
The hardware utilized are RS-485 transceivers wired for open collector operation through the use of a pullup and pulldown of the separate data lines. Transmission is accomplished by controlling the driver enable pin of the transceiver. This method allows multiple devices to share the bus without the need for a single master node.
Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (e.g. controller) and a slave (e.g. sensor). SSI is based on RS-422 [1] standards and has a high protocol efficiency in addition to its implementation over various hardware platforms, making it very popular among sensor manufacturers.