Search results
Results from the WOW.Com Content Network
Formula of glass component Desired concentration of glass component, wt% Molar mass of glass component, g/mol Batch component Formula of batch component Molar mass of batch component, g/mol SiO 2: 67 60.0843 Sand SiO 2: 60.0843 Na 2 O 12 61.9789 Trona: Na 3 H(CO 3) 2 *2H 2 O 226.0262 CaO 10 56.0774 Lime CaCO 3: 100.0872 Al 2 O 3: 5 101.9613 ...
The rectifying section operating line for the section above the inlet feed stream of the distillation column (shown in green in Figure 1) starts at the intersection of the distillate composition line and the x = y line and continues at a downward slope of L / (D + L), where L is the molar flow rate of reflux and D is the molar flow rate of the ...
The Bogacki–Shampine method is implemented in the ode3 for fixed step solver and ode23 for a variable step solver function in MATLAB (Shampine & Reichelt 1997). Low-order methods are more suitable than higher-order methods like the Dormand–Prince method of order five, if only a crude approximation to the solution is required.
As an example, consider the gas-phase reaction NO 2 + CO → NO + CO 2.If this reaction occurred in a single step, its reaction rate (r) would be proportional to the rate of collisions between NO 2 and CO molecules: r = k[NO 2][CO], where k is the reaction rate constant, and square brackets indicate a molar concentration.
Iterative methods such as Newton's method are often used to solve the implicit formula. Sometimes an explicit multistep method is used to "predict" the value of +. That value is then used in an implicit formula to "correct" the value. The result is a predictor–corrector method.
where M is the molar mass of the substance (usually given in SI units of grams per mole) and v is the valency of the ions. For Faraday's first law, M, F, v are constants; thus, the larger the value of Q, the larger m will be.
The Mayo–Lewis equation or copolymer equation in polymer chemistry describes the distribution of monomers in a copolymer. It was proposed by Frank R. Mayo and Frederick M. Lewis . [ 1 ]
Here k is the first-order rate constant, having dimension 1/time, [A](t) is the concentration at a time t and [A] 0 is the initial concentration. The rate of a first-order reaction depends only on the concentration and the properties of the involved substance, and the reaction itself can be described with a characteristic half-life. More than ...