Search results
Results from the WOW.Com Content Network
The Merrill Wheel-Balancing System was the world's first electronic dynamic wheel-balancing system. It was invented in 1945 by Marcellus Merrill at the Merrill Engineering Laboratories, 2390 South Tejon Street, Englewood, Colorado , and is now recorded on the list of IEEE Milestones in electronic engineering [ 1 ] and as an American Society of ...
In the case of a narrow wheel, balancing simply involves moving the center of gravity to the centre of rotation. For a system to be in complete balance both force and couple polygons should be close in order to prevent the effect of centrifugal force. It is important to design the machine parts wisely so that the unbalance is reduced up to the ...
If the tire is not checked, it has the potential to cause vibration in the suspension of the vehicle on which it is mounted. In tire retail shops, tire/wheel assemblies are checked on a spin-balancer, which determines the amount and angle of unbalance. Balance weights are then fitted to the outer and inner flanges of the wheel. [2]
A wheel hub with a castellated nut secured in the center using a cotter pin to prevent it from unscrewing. A positive locking device is a device used in conjunction with a fastener in order to positively lock the fastener. This means that the fastener cannot work loose from vibrations. The following is a list of positive locking devices: [1]
An axlebox, also known as a journal box in North America, is the mechanical subassembly on each end of the axles under a railway wagon, coach or locomotive; it contains bearings and thus transfers the wagon, coach or locomotive weight to the wheels and rails; the bearing design is typically oil-bathed plain bearings on older rolling stock, or roller bearings on newer rolling stock.
However a static balancer can only correct in one plane, so its accuracy is limited. A blade balancing machine attempts to balance a part in assembly, so minimal correction is required later on. Blade mass balancing is typically done for short blades, while long blades may require moment weighing in one or two axes.
Plate spinners. Plate spinning is a circus manipulation art where a person spins plates, bowls and other flat objects on poles, without them falling off. Plate spinning relies on the gyroscopic effect, in the same way a top stays upright while spinning. Spinning plates are sometimes gimmicked, to help keep the plates on the poles. [1]
Pin and hanger assembly. A pin and hanger assembly is used to connect two plate girders of a bridge.These assemblies are used to provide an expansion joint in the bridge. One beam (the anchor span) is set on a pier with a short section cantilevered out toward the next pier.