Search results
Results from the WOW.Com Content Network
The name refers to the ability of the disk to flex along its main axis to account for gear changes and/or small misalignments as rotational speeds change. [2] Flexplates are generally much thinner and lighter than flywheels not only because of the required flexibility, but also due to the smoother coupling action of the torque converter [3] and the elimination of the clutch surface.
Dual-mass flywheel section. A dual-mass flywheel (DMF or DMFW) is a rotating mechanical device that is used to provide continuous energy (rotational energy) in systems where the energy source is not continuous, the same way as a conventional flywheel acts, but damping any violent variation of torque or revolutions that could cause an unwanted vibration.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The 4-8-2 wheel arrangement has four leading wheels on two axles, usually in a leading bogie, eight powered and coupled driving wheels on four axles and two trailing wheels on one axle, usually in a trailing truck. Since the 4-8-2 type is generally known as a Mountain, the corresponding Garratt type is usually known as a Double Mountain. [1]
2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines. Some had the same Mitsubishi manual transmission as the 2.0/2.3 but had different bellhousings. The 2.3, 2.8, and 2.9 also made it into the Ranger, and Bronco II. 4.0L was produced by Ford Cologne Germany (like the unrelated and the all-new metric Taurus/Sable FWD 3.0 V6).
The first 6-speed manual transmission was introduced in the 1967 Alfa Romeo 33 Stradale. The first 7-speed manual transmission was introduced in the 2012 Porsche 911 (991). [9] In 2008, 75.2% of vehicles produced in Western Europe were equipped with manual transmission, versus 16.1% with automatic and 8.7% with other. [10]
4.6957 0.6667 8 7.0435 1.3216 1.7693 P & S 4 2 3 Torque Converter w/ Lockup Electronic 8HP 30 1st 300 N⋅m (221 lb⋅ft) 2010 – 2015 Longitudinal: 4.7143 0.6667 8 7.0714 1.3224 1.7728 P & S 4 2 3 Torque Converter w/ Lockup Electronic 8HP 45 1st 450 N⋅m (332 lb⋅ft) 2010 – 2015 Longitudinal: 4.7143 0.6667 8 7.0714 1.3224 1.7728 P & S 4 2 ...
The TH400 was phased out for the 1980 models, when the A-727 replaced the TH-400 as the only automatic transmission option for both the SJ Wagoneer/Cherokee wagons and the J-10/J-20 trucks. Internally similar to the Chrysler A-727, the case was one-piece, cast with an AMC pattern bellhousing (not interchangeable with a Chrysler pattern A-727).