Search results
Results from the WOW.Com Content Network
A settling chamber (or stiveroom) [6] consists of a large box installed in the ductwork. The increase of cross section area at the chamber reduces the speed of the dust-filled airstream and heavier particles settle out. Settling chambers are simple in design and can be manufactured from almost any material.
The height of the heavy phase weir can be adjusted in order to position the heavy/light interphase in the settling chamber based on the density of each one of the phases. The settler is a calm pool downstream of the mixer where the liquids are allowed to separate by gravity. The liquids are then removed separately from the end of the mixer.
Settling pond for iron particles at water works. Settling is the process by which particulates move towards the bottom of a liquid and form a sediment.Particles that experience a force, either due to gravity or due to centrifugal motion will tend to move in a uniform manner in the direction exerted by that force.
Cumulate rock – Igneous rocks formed by the accumulation of crystals from a magma either by settling or floating. Flow banding – Bands or layers that can sometimes be seen in rock that formed from magma; Fractional crystallization (chemistry) – Method for refining substances based on differences in their solubility
A vessel that includes (a) primary separation device and/or section, (b) secondary "gravity" settling (separating) section, (c) mist extractor to remove small liquid particles from the gas, (d) gas outlet, (e) liquid settling (separating) section to remove gas or vapor from oil (on a three-phase unit, this section also separates water from oil ...
Gravitational sedimentation – the settling of particles fall down due to gravity. Interception. This is when small particles follow the streamlines, but if they flow too close to an obstacle, they may collide (e.g. a branch of a tree). Turbulence. Turbulent eddies in the air transfer particles which can collide. Again, there is a net flux ...
The settling particles can contact each other and arise when approaching the floor of the sedimentation tanks at very high particle concentration. So that further settling will only occur in adjust matrix as the sedimentation rate decreasing. This is can be illustrated by the lower region of the zone-settling diagram (Figure 3).
A decanter centrifuge increases the rate of settling through the use of continuous rotation, producing a G-force equivalent to between 1000 and 4000 G's. This reduces the settling time of the components by a large magnitude, whereby mixtures previously having to take hours to settle can be settled in a matter of seconds using a decanter centrifuge.