Search results
Results from the WOW.Com Content Network
The same engine at sea level will achieve that same 50 kPa (7.25 psi, 14.7 inHG) of manifold pressure at less than (before reaching) WOT due to the higher barometric pressure. The engine requires the same mass of fuel in both conditions because the mass of air entering the cylinders is the same.
A bad crank position sensor can worsen the way the engine idles, or the acceleration behaviour. If the engine is revved up with a bad or faulty sensor, it may cause misfiring, motor vibration or backfires. Acceleration might be hesitant, and abnormal shaking during engine idle might occur. In the worst case, the car may not start.
Fuel pressure regulator; Rev limiter; Wastegate control and anti-lag; Theft prevention by blocking ignition, in response to input from an immobiliser; In a camless piston engine (an experimental design not currently used in any production vehicles), the ECU has continuous control of when each of the intake and exhaust valves are opened and by ...
Vapor lock is a problem caused by liquid fuel changing state to vapor while still in the fuel delivery system of gasoline-fueled internal combustion engines.This disrupts the operation of the fuel pump, causing loss of feed pressure to the carburetor or fuel injection system, resulting in transient loss of power or complete stalling.
Low-speed pre-ignition (LSPI), also known as stochastic pre-ignition (SPI), [1] is a pre-ignition event that occurs in gasoline vehicle engines when there is a premature ignition of the main fuel charge. [2] LSPI is most common in certain turbocharged direct-injection vehicles operating in low-speed and high-load driving conditions. [3]
There’s only so far you can go with an air-throttled engine on 91-octane gasoline. In other words, it is the fuel, gasoline, that has become the limiting factor. ... While turbocharging has been applied to both gasoline and diesel engines, only limited boost can be added to a gasoline engine before the fuel octane level again becomes a problem.
Petrol engines can often be adapted to also run on fuels such as liquefied petroleum gas and ethanol blends (such as E10 and E85). They may be designed to run on petrol with a higher octane rating, as sold at petrol stations. Most petrol engines use spark ignition, unlike diesel engines which run on diesel fuel and typically use compression ...
An engine test stand is a facility used to develop, characterize and test engines. The facility, often offered as a product to automotive OEMs, allows engine operation in different operating regimes and offers measurement of several physical variables associated with the engine operation.