enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. FlashPath - Wikipedia

    en.wikipedia.org/wiki/FlashPath

    FlashPath is hardware compatible with all standard 3.5" High-Density Floppy disk drives, but is not a drop-in replacement for real floppy disks. A special software device driver must be installed on the computer that is to access data via FlashPath. Thus, FlashPath is only usable with computers and operating systems for which such a driver ...

  3. KryoFlux - Wikipedia

    en.wikipedia.org/wiki/KryoFlux

    The KryoFlux controller plugs into a standard USB port, and allows normal PC floppy disk drives to be plugged into it. Because the device operates on data bits at the lowest possible level with very precise timing resolution, it allows modern PCs to read, decode and write floppy disks that use practically any data format or method of copy ...

  4. Floppy disk hardware emulator - Wikipedia

    en.wikipedia.org/wiki/Floppy_disk_hardware_emulator

    The floppy disk emulator can provide other systems access to the data on the emulated floppy in a number of ways: Direct access to some dedicated disk partition (e.g.: a 1.44MB partition on a USB key) Floppy file system translation (e.g.: FAT12 floppy ↔ USB key folder) Floppy disk images (e.g.: raw floppy ↔ .img/.iso USB key file)

  5. Floppy disk - Wikipedia

    en.wikipedia.org/wiki/Floppy_disk

    8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...

  6. Berg connector - Wikipedia

    en.wikipedia.org/wiki/Berg_connector

    Some of the more familiar ones used in IBM PC compatibles are: the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a "floppy power connector", but often also referred to as LP4. This connector has a 2.50 mm (0.098 in) pitch (not 2.54 mm).

  7. List of floppy disk formats - Wikipedia

    en.wikipedia.org/wiki/List_of_floppy_disk_formats

    drive: 1, diskette: 2 16 8 512 2× 64 kB 270 GCR (4/5) Internally based on FDU-250 Micro Floppy Disk Drive Unit [2] Thomson: 5 1 ⁄ 4 inch Single 1 40 16 128 80 kB 300 FM Thomson UD90.070 Double 2 256 320 kB MFM Thomson DD90-320 [NB 17] 3 1 ⁄ 2 inch Double 1 80 16 256 320 kB 300 MFM Thomson TO9, Thomson DD09-350 Double 2 640 kB

  8. Commodore 1581 - Wikipedia

    en.wikipedia.org/wiki/Commodore_1581

    An internal floppy drive and controller are required as well; USB floppy drives operate strictly at the file system level and do not allow low-level disk access. [9] The WD1770 controller chip, however, was the seat of some early problems with 1581 drives when the first production runs were recalled due to a high failure rate; the problem was ...

  9. Floppy disk drive interface - Wikipedia

    en.wikipedia.org/wiki/Floppy_disk_drive_interface

    3.5-inch and 5.25-inch drives connect to the floppy controller using a 34-conductor flat ribbon cable for signal and control. Most controllers support two floppy drives, although the Shugart standard supports up to four drives attached to a single controller. A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a ...