enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. American wire gauge - Wikipedia

   en.wikipedia.org/wiki/American_wire_gauge

   (E.g. 1 mm diameter wire is ≈18 AWG, 2 mm diameter wire is ≈12 AWG, and 4 mm diameter wire is ≈6 AWG.) This quadruples the cross-sectional area and conductance. A decrease of ten gauge numbers (E.g. from 24 AWG to 14 AWG) multiplies the area, weight, and conductance by approximately 10.

3. Trailer connectors in North America - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   AWG; 1 31: Ground connected to chassis: White: 10: 8: 2 Reversing lamps, control current to block surge brakes when reversing. Red or Purple: 6: 10: 3 L54: Left Turn Signal, Stop lamps: Yellow: 4: 12: 4 15 +12 V via ignition lock: Black: 10: 8: 5 R54: Right Turn Signal, Stop lamps: Green: 4: 12: 6 58: Tail lamps, clearance lamps/outline marker ...

4. Wire gauge - Wikipedia

   en.wikipedia.org/wiki/Wire_gauge

   In some cases both edges are graduated differently in order to allow comparison between two systems of measurement. A few gauges are made with holes into which the wire has to be thrust. All gauges are hardened and ground to dimensions. In some applications wire sizes are specified as the cross sectional area of the wire, usually in mm 2.

5. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.

6. Twist-on wire connector - Wikipedia

   en.wikipedia.org/wiki/Twist-on_wire_connector

   [4] Special feedthrough twist-on wire connectors differ from standard wire connectors in that they have an additional opening at the top of the insulated cap. This allows a single-conductor bare wire to be pushed through the hole, forming a "pigtail" section which can be attached to a grounding screw.

7. Trailer connectors in Europe - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in_Europe

   Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...