Search results
Results from the WOW.Com Content Network
UPnP logo as promoted by the UPnP Forum (2001–2016) and Open Connectivity Foundation (2016–present). Universal Plug and Play (UPnP) is a set of networking protocols on the Internet Protocol (IP) that permits networked devices, such as personal computers, printers, Internet gateways, Wi-Fi access points and mobile devices, to seamlessly discover each other's presence on the network and ...
The WAN interface of this device, in this case the DSL port, could expose CWMP to the internet service provider. Technical Report 069 ( TR-069 ) is a document by the Broadband Forum that specifies the CPE WAN Management Protocol ( CWMP ).
Port mirroring on a Cisco Systems switch is generally referred to as Switched Port Analyzer (SPAN) or Remote Switched Port Analyzer (RSPAN). Other vendors have different names for it, such as Roving Analysis Port (RAP) on 3Com switches. Network engineers or administrators use port mirroring to analyze and debug data or diagnose errors on a ...
Wi-Fi (/ ˈ w aɪ f aɪ /) [1] [a] is a family of wireless network protocols based on the IEEE 802.11 family of standards, which are commonly used for local area networking of devices and Internet access, allowing nearby digital devices to exchange data by radio waves.
Port Control Protocol (PCP) is a computer networking protocol that allows hosts on IPv4 or IPv6 networks to control how the incoming IPv4 or IPv6 packets are translated and forwarded by an upstream router that performs network address translation (NAT) or packet filtering.
Suppose one has a Wi-Fi-capable game console. This device needs to send one packet to a WAN host, and receive one packet in reply. Network 1: A wireless base station acting as a simple (non-WDS) wireless router. The packet leaves the game console, goes over-the-air to the router, which then transmits it across the WAN.
Some wireless routers have one or two USB ports. These can be used to connect printer or desktop or mobile external hard disk drive to be used as a shared resource on the network. [2] A USB port may also be used for connecting mobile broadband modem, [3] aside from connecting the wireless router to an Ethernet with xDSL or cable modem. A mobile ...
The Raspberry Pi 3 and Pi Zero W (wireless) are equipped with 2.4 GHz WiFi 802.11n (150 Mbit/s) and Bluetooth 4.1 (24 Mbit/s) based on the Broadcom BCM43438 FullMAC chip with no official support for monitor mode (though it was implemented through unofficial firmware patching [103]) and the Pi 3 also has a 10/100 Mbit/s Ethernet port.