Search results
Results from the WOW.Com Content Network
Another example would be a manufacturing facility classified as ordinary hazard group 2 where a typical design area would be 1,500 square feet (140 m 2) and the design density would be 0.2 US gallons per minute (0.76 L/min) per 1 square foot (0.093 m 2) or a minimum of 300 US gallons per minute (1,100 L/min) applied over the 1,500-square-foot ...
[2] Victaulic specializes in the development of couplings, valves, and fitting technologies for a variety of industries. Its main products are: Grooved couplings used to join mechanical pipes together. [3] The company produces a variety of these grooved couplings along with other technologies since it was founded. [4]
External access point for fire sprinkler and dry standpipe at a building in San Francisco, US Antique wet standpipe preserved at Edison and Ford Winter Estates. A standpipe or riser is a type of rigid water piping which is built into multi-story buildings in a vertical position, or into bridges in a horizontal position, to which fire hoses can be connected, allowing manual application of water ...
This fitting (also known as a "bungalow fitting" or a "cottage fitting") is a sanitary tee that allows two trap arms to be connected at the same level. A toilet is the main connection, with the option of a right or left-hand outlet to the 3" inlet with a choice of 1-1/2" or 2" in size.
In general well heads are five nominal ratings of wellheads: 2, 3, 5, 10 and 15 (×1000) psi working pressure. They have an operating temperature range of −50 to +250 degrees Fahrenheit. They are used in conjunction with ring type seal gaskets. In general the yield strength of the materials range from 36000 to 75000 psi.
A schematic, or schematic diagram, is a designed representation of the elements of a system using abstract, graphic symbols rather than realistic pictures. A schematic usually omits all details that are not relevant to the key information the schematic is intended to convey, and may include oversimplified elements in order to make this essential meaning easier to grasp, as well as additional ...
A crosshead as part of a reciprocating piston and slider-crank linkage mechanism. Cylindrical trunk guide Hudswell Clarke Nunlow; crosshead and two slide bars. In mechanical engineering, a crosshead [1] is a mechanical joint used as part of the slider-crank linkages of long stroke reciprocating engines (either internal combustion or steam) and reciprocating compressors [2] to eliminate ...
The larger boilers were 15 feet 9 inches (4.80 m) in diameter and 20 feet (6.1 m) long, the smaller were 11 feet 9 inches (3.58 m) in length. All ends had three corrugated Morrison furnaces of 3 feet 9 inches (1.14 m) diameter, 159 furnaces in total, and a working pressure of 215 pounds per square inch (1,480 kPa).