Search results
Results from the WOW.Com Content Network
Different types of sport climbing problems: (1) Dihedral, (2) Slab, (3) Wall, (4) Overhang, (5) Edge, (6) Roof and (7) Traverse climbing. The simplest type of wall is of plywood construction, known colloquially in the climbing community as a 'woody', with a combination of either bolt-on holds or screw-on holds. Bolt-on holds are fixed to a wall ...
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
Tilt-up, tilt-slab or tilt-wall is a type of building and a construction technique using concrete. Though it is a cost-effective technique with a shorter completion time, [ 1 ] poor performance in earthquakes has mandated significant seismic retrofit requirements in older buildings.
In Latin America, contractors have started to use a form of lift slab construction where load-bearing concrete walls are raised at the same time as the floor slabs. Both the wall panels and the floor slabs are cast on the ground. The walls are attached to the slabs through hinges formed by plastic ropes. As the floors are raised, the walls ...
(Greek: ὀρθοστάτης, standing upright) The Greek term for the lowest course of masonry of the external walls of the naos or cella, consisting of vertical slabs of stone or marble equal in height to two or three of the horizontal courses which constitute the inner part of the wall. [68] Orthostyle
The batter angle is typically described as a ratio of the offset and height or a degree angle that is dependent on the building materials and application. For example, typical dry-stone construction of retaining walls utilizes a 1:6 ratio, that is for every 1 inch that the wall steps back, it increases 6 inches in height. [5]
When installed in a kitchen on standard (U.S) wall-mounted base unit cabinets, countertops are typically about 25–26 inches (640–660 millimetres) from front to back and are designed with a slight overhang on the front (leading) edge. This allows for a convenient reach to objects at the back of the countertop while protecting the base ...
On the south-western elevation the edge of the roof is finished with a half-metre wide, solid valance of shot-edge timber boards. The building sheltering under the roof sits on a concrete slab-on-ground. The walls are clad in weatherboards to a height off the ground of approximately 600 millimetres (24 in).