enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors. [2] [3] JST connectors are used in many types of products, and commonly used by electronics hobbyists and consumer products for rechargeable battery packs, battery balancers, battery eliminator circuits, 3D printers, and radio controlled servos. [4]

3. Category:Electrical signal connectors - Wikipedia

   en.wikipedia.org/wiki/Category:Electrical_signal...

   Audiovisual connectors (3 C, 31 P) C. Computer buses ... JST connector; K. Keystone module; M. Male box header; Male pin header;

4. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   When working with multi-pin connectors, it is helpful to have a pinout diagram to identify the wire or circuit node connected to each pin. Some connector styles may combine pin and socket connection types in a single unit, referred to as a hermaphroditic connector. [6]: 56 These connectors includes mating with both male and female aspects ...

5. DC connector - Wikipedia

   en.wikipedia.org/wiki/DC_connector

   A male 4-pin "Kycon" power connector, which appears similar to a Mini-DIN connector Right-angle DC connector. Snap and lock DC power connectors look similar to Mini-DIN connectors but have either 3 or 4 thicker pins and a slightly larger mating shell. Because of this, they do not mate with any of the standardized Mini-DIN connectors.

6. Industrial and multiphase power plugs and sockets - Wikipedia

   en.wikipedia.org/wiki/Industrial_and_multiphase...

   Semko 17 were 3/4-pin 3-phase connectors, with (4-pin) or without (3-pin) a neutral connector. Earth were provided via the shield. The connectors were available in different sizes, 16 A with rounded corners; 25 A and 63 A were rectangular. These connectors were used mainly in industrial and agricultural installations.

7. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.