Search results
Results from the WOW.Com Content Network
A General encoder's block diagram. An encoder (or "simple encoder") in digital electronics is a one-hot to binary converter. That is, if there are 2 n input lines, and at most only one of them will ever be high, the binary code of this 'hot' line is produced on the n-bit output lines. A binary encoder is the dual of a binary decoder.
This is a list of some binary codes that are (or have been) used to represent text as a sequence of binary digits "0" and "1". Fixed-width binary codes use a set number of bits to represent each character in the text, while in variable-width binary codes, the number of bits may vary from character to character.
In computer science, the double dabble algorithm is used to convert binary numbers into binary-coded decimal (BCD) notation. [ 1 ] [ 2 ] It is also known as the shift-and-add -3 algorithm , and can be implemented using a small number of gates in computer hardware, but at the expense of high latency .
One way to increment a Gray code number is to convert it into ordinary binary code, [55] add one to it with a standard binary adder, and then convert the result back to Gray code. [56] Other methods of counting in Gray code are discussed in a report by Robert W. Doran , including taking the output from the first latches of the master-slave flip ...
BCD-to-binary converter three-state 20 SN74S484A: 74x485 1 binary-to-BCD converter three-state 20 SN74S485A: 74x488 1 IEEE-488 bus interface 48 74ACT488: 74x490 2 dual decade counter 16 SN74490: 74x491 1 10-bit binary up/down counter, limited preset three-state 24 SN74LS491: 74x498 1 8-bit bidirectional shift register, parallel inputs three ...
The word 'Wikipedia' represented in ASCII binary code, made up of 9 bytes (72 bits). A binary code represents text, computer processor instructions, or any other data using a two-symbol system. The two-symbol system used is often "0" and "1" from the binary number system. The binary code assigns a pattern of binary digits, also known as bits ...
Compared to these, a flash converter is also quite simple and, apart from the analog comparators, only requires logic for the final conversion to binary. For best accuracy, a track-and-hold circuit is often inserted in front of an ADC input.
In digital electronics, a binary decoder is a combinational logic circuit that converts binary information from the n coded inputs to a maximum of 2 n unique outputs. They are used in a wide variety of applications, including instruction decoding, data multiplexing and data demultiplexing, seven segment displays, and as address decoders for memory and port-mapped I/O.