Search results
Results from the WOW.Com Content Network
The counter itself must count in Gray code, or if the counter runs in binary then the output value from the counter must be reclocked after it has been converted to Gray code, because when a value is converted from binary to Gray code, [nb 1] it is possible that differences in the arrival times of the binary data bits into the binary-to-Gray ...
The principle is to adjust the DAC's input code until the DAC's output comes within ± 1 ⁄ 2 LSB to the analog input which is to be converted to binary digital form. Servo tracking ADC: It is an improved version of a counting ADC. The circuit consists of an up-down counter with the comparator controlling the direction of the count.
BCD-to-binary converter three-state 20 SN74S484A: 74x485 1 binary-to-BCD converter three-state 20 SN74S485A: 74x488 1 IEEE-488 bus interface 48 74ACT488: 74x490 2 dual decade counter 16 SN74490: 74x491 1 10-bit binary up/down counter, limited preset three-state 24 SN74LS491: 74x498 1 8-bit bidirectional shift register, parallel inputs three ...
Six-bit BCD code was the adaptation of the punched card code to binary code. IBM applied the terms binary-coded decimal and BCD to the variations of BCD alphamerics used in most early IBM computers, including the IBM 1620 , IBM 1400 series , and non- decimal architecture members of the IBM 700/7000 series .
The ARINC 429 unit of transmission is a fixed-length 32-bit frame, which the standard refers to as a 'word'. The bits within an ARINC 429 word are serially identified from Bit Number 1 to Bit Number 32 [4] or simply Bit 1 to Bit 32. The fields and data structures of the ARINC 429 word are defined in terms of this numbering.
The word 'Wikipedia' represented in ASCII binary code, made up of 9 bytes (72 bits). A binary code represents text, computer processor instructions, or any other data using a two-symbol system. The two-symbol system used is often "0" and "1" from the binary number system. The binary code assigns a pattern of binary digits, also known as bits ...
A General encoder's block diagram. An encoder (or "simple encoder") in digital electronics is a one-hot to binary converter. That is, if there are 2 n input lines, and at most only one of them will ever be high, the binary code of this 'hot' line is produced on the n-bit output lines. A binary encoder is the dual of a binary decoder.
A flash ADC (also known as a direct-conversion ADC) is a type of analog-to-digital converter that uses a linear voltage ladder with a comparator at each "rung" of the ladder to compare the input voltage to successive reference voltages.