enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Trapezoidal thread form - Wikipedia

    en.wikipedia.org/wiki/Trapezoidal_thread_form

    This thread form also allows for the use of a split nut, which can compensate for nut wear. [8] The line of General Purpose (GP) Acme threads (ASME/ANSI B1.5-1997) are not designed to sustain external radial loads and both the nut and bolt are, ideally, independently supported (the nut by a linear guide and the screw by shaft bearings).

  3. Screw thread - Wikipedia

    en.wikipedia.org/wiki/Screw_thread

    The minimum limits for external (or bolt, in ISO terminology), and the maximum limits for internal (nut), thread sizes are there to ensure that threads do not strip at the tensile strength limits for the parent material. The minimum limits for internal, and maximum limits for external, threads are there to ensure that the threads fit together.

  4. Square thread form - Wikipedia

    en.wikipedia.org/wiki/Square_thread_form

    The square thread form is a common screw thread profile, used in high load applications such as leadscrews and jackscrews. It gets its name from the square cross-section of the thread. [ 1 ] It is the lowest friction and most efficient thread form, but it is difficult to fabricate.

  5. ISO metric screw thread - Wikipedia

    en.wikipedia.org/wiki/ISO_metric_screw_thread

    Basic profile of all ISO metric screw threads, where the male part has the external thread. The design principles of ISO general-purpose metric screw threads ("M" series threads) are defined in international standard ISO 68-1. [2] Each thread is characterized by its major diameter, D (D maj in the diagram), and its pitch, P. ISO metric threads ...

  6. Unified Thread Standard - Wikipedia

    en.wikipedia.org/wiki/Unified_Thread_Standard

    In an external (male) thread (e.g., on a bolt), the major diameter D maj and the minor diameter D min define maximum dimensions of the thread. This means that the external thread must end flat at D maj, but can be rounded out below the minor diameter D min. Conversely, in an internal (female) thread (e.g., in a nut), the major and minor ...

  7. Engineering drawing abbreviations and symbols - Wikipedia

    en.wikipedia.org/wiki/Engineering_drawing...

    CAD: computer-aided design, computer-aided drafting; cadmium [plating]: CAGE: Commercial and Government Entity [code]: A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing.

  8. Knuckle thread - Wikipedia

    en.wikipedia.org/wiki/Knuckle_thread

    Knuckle threads with a flat 30 degree flank thread angle are standardized in DIN 405 for inch pitches and diameters ranging from 8 mm to 200 mm. [3] A more recent standard DIN 20400 uses metric thread pitch and lists diameters from 10 mm to 300 mm. [4] As DIN is a German organization, many instances of the DIN thread charts [5] write numbers with a comma as the decimal marker.

  9. Buttress thread - Wikipedia

    en.wikipedia.org/wiki/Buttress_thread

    In oil field tubing, buttress thread is a pipe thread form designed to provide a tight hydraulic seal. The thread form is similar to that of Acme thread [10] but there are two distinct threaded portions of differing diameters and profiles, the larger having a wedging profile, with a tapered sealing portion in between the larger and smaller diameters.