Search results
Results from the WOW.Com Content Network
As mentioned above, when converting UTM coordinates to an MGRS grid reference, or when abbreviating an MGRS grid reference to lower precision, one should truncate the coordinates, not round. This has been controversial in the past, since the oldest specification, TM8358.1, [ 1 ] used rounding, as did GEOTRANS [ 4 ] before version 3.0.
degrees and decimal minutes: 40° 26.767′ N 79° 58.933′ W; decimal degrees: +40.446 -79.982; There are 60 minutes in a degree and 60 seconds in a minute. Therefore, to convert from a degrees minutes seconds format to a decimal degrees format, one may use the formula
Grid Zone Designation (GZD); for a world-wide unique address. This consists of up to 2 digits (6-degree longitude UTM zone) for West to East, followed by a letter (8-degree latitude band) from South to North; in this example, "18S". [10] [11] 100,000-meter (100 km) Square Identification; for regional areas.
Decimal degrees (DD) is a notation for expressing latitude and longitude geographic coordinates as decimal fractions of a degree. DD are used in many geographic information systems (GIS), web mapping applications such as OpenStreetMap , and GPS devices.
Under the Chairman of the Joint Chiefs of Staff Instruction CJCSI 3900.01C dated 30 June 2007, GARS was adopted for use by the US DoD as "the “area-centric” counterpart to the “point-centric” MGRS". It uses the WGS 1984 Datum and is based on lines of longitude (LONG) and latitude (LAT). It is intended to provide an integrated common ...
For example, in the Military Grid Reference System, the above coordinate is in grid 11U (representing UTM Zone 11 5xxxxxx mN), and grid cell NS within that (representing the second digit 5xxxxxmE x6xxxxxm N), and as many remaining digits as are needed are reported, yielding an MGRS grid reference of 11U NS 949 361 (or 11U NS 9493 3617 or 11U NS ...
The geographical coordinates are embedded in the email link which is then displayed. The coordinates are the two numbers displayed immediately after the letters "cp=". The latitude and longitude are separated by a tilde ( ~ ). The latitude is displayed first, and both coordinates are displayed in decimal degrees format. (in degrees only).
The reverse conversion is harder: given X-Y-Z can immediately get longitude, but no closed formula for latitude and height exists. See "Geodetic system." Using Bowring's formula in 1976 Survey Review the first iteration gives latitude correct within 10-11 degree as long as the point is within 10,000 meters above or 5,000 meters below the ellipsoid.