enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Gimlet (tool) - Wikipedia

   en.wikipedia.org/wiki/Gimlet_(tool)

   A gimlet is a hand tool for drilling small holes, mainly in wood, without splitting. It was defined in Joseph Gwilt's Architecture (1859) as "a piece of steel of a semi-cylindrical form, hollow on one side, having a cross handle at one end and a worm or screw at the other". [1] A gimlet is always a small tool.

3. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   The use of reamed dowel holes is typical in any machine design, where any two locating parts have to be located and mated accurately to one another - typically as indicated above, to within 0.02 mm or less than .001". Another use of reamed holes is to receive a specialized bolt that has an unthreaded shoulder - also called a shoulder bolt.

4. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The brad point drill bit (also known as lip and spur drill bit, and dowel drill bit) is a variation of the twist drill bit which is optimized for drilling in wood. Conventional twist drill bits tend to wander when presented to a flat workpiece. For metalwork, this is countered by drilling a pilot hole with a spotting drill bit.

5. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1] When drilling larger holes, where the drill bit is wider than the indentation produced by a center punch, the drilling of a pilot hole is usually needed.

6. Brace (tool) - Wikipedia

   en.wikipedia.org/wiki/Brace_(tool)

   A brace is a hand tool used with a bit (drill bit or auger) to drill holes, usually in wood. Pressure is applied to the top while the handle is rotated. If the bit's lead and cutting spurs are both in good working order, the user should not have to apply any pressure other than for balance: the lead will pull the bit through the wood.

7. Dowel - Wikipedia

   en.wikipedia.org/wiki/Dowel

   A dowel plate. The traditional tool for making dowels is a dowel plate, an iron (or better, hardened tool steel) plate with a hole having the size of the desired dowel.To make a dowel, a piece of wood is split or whittled to a size slightly bigger than desired and then driven through the hole in the dowel plate.