Search results
Results from the WOW.Com Content Network
SWR is used as a measure of impedance matching of a load to the characteristic impedance of a transmission line carrying radio frequency (RF) signals. This especially applies to transmission lines connecting radio transmitters and receivers with their antennas, as well as similar uses of RF cables such as cable television connections to TV receivers and distribution amplifiers.
It is possible to also get a bad picture if the signal strength of the TV transmitter is too high. An attenuator inserted in the antenna lead-in wire may be used if the television receiver displays signs of overload in the RF front end. Strong out-of-band signals may also affect television reception and may require band-pass filters to reduce ...
In telecommunications, [1] particularly in radio frequency engineering, signal strength refers to the transmitter power output as received by a reference antenna at a distance from the transmitting antenna. High-powered transmissions, such as those used in broadcasting, are expressed in dB-millivolts per metre (dBmV/m).
Radio frequency (RF) energy at power density levels of 1–10 mW/cm 2 or higher can cause measurable heating of tissues. Typical RF energy levels encountered by the general public are well below the level needed to cause significant heating, but certain workplace environments near high power RF sources may exceed safe exposure limits. [7]
The signal path from the BTS antenna normally elevated above the roof tops is refracted down into the local physical environment (hills, trees, houses) and the LOS signal seldom reaches the antenna. The environment will produce several deflections of the direct signal onto the antenna, where typically 2–5 deflected signal components will be ...
The "primary service area" is the area served by a station's strongest signal. The "city-grade contour" is 70 dBμ (decibels relative to one microvolt per meter of signal strength) or 3.16mV/m (millivolts per meter) for FM stations in the United States, according to Federal Communications Commission (FCC) regulations.
A link budget is an accounting of all of the power gains and losses that a communication signal experiences in a telecommunication system; from a transmitter, through a communication medium such as radio waves, cable, waveguide, or optical fiber, to the receiver.
An SWR meter does not measure the actual impedance of a load (the resistance and reactance), but only the mismatch ratio. To measure the actual impedance requires an antenna analyzer or other similar RF measuring device. For accurate readings, the SWR meter itself must also match the line's impedance (typically 50 or 75 Ohms).