Search results
Results from the WOW.Com Content Network
Typical live use of a multicore (thick cable on stage) Multicores usually create a link between the stage and sound desk, or live room and control room.When used in sound reinforcement, the multicore cable runs from the stage box or microphone splitter to the front-of-house sound desk, where it connects to a mixing console. [2]
A Shure FP24 preamp's mono XLR line outputs connected to an Edirol R-09 recorder's 3.5mm stereo jack line input, using a Y-cable. This is an example of consolidating connectors, as described below. A Y-cable, Y cable, or splitter cable is a cable with three ends: one common end and two other ends. The Y-cable can resemble the Latin letter "Y".
AoE systems use a much higher bit rate (typically 1 Mbit/s per channel) and much lower latency (typically less than 10 milliseconds) than VoIP. AoE requires a high-performance network. Performance requirements may be met through use of a dedicated local area network (LAN) or virtual LAN (VLAN), overprovisioning or quality of service features.
Carries standard definition video and does not carry audio on the same cable. Mini-DIN 4-pin Component. In popular use, it refers to a type of analog video information that is transmitted or stored as three separate signals. Either RGB interfaces or YPbPr: 3 RCA jacks: Composite, S-Video, and Component: VIVO = Mini-DIN 9-pin with breakout cable.
Look-ahead is implemented by splitting the input signal and delaying one side (the audio signal) by the look-ahead time. The non-delayed side (the gain control signal) is used to drive the compression of the delayed signal, which then appears at the output. This way a smooth-sounding slower attack rate can be used to catch transients.
Balanced audio connections use a number of techniques to reduce noise. A typical balanced cable contains two identical wires, which are twisted together and then wrapped with a third conductor (foil or braid) that acts as a shield. The two wires form a circuit that can carry an audio signal.
Comcast last month plans to split most of its NBCUniversal cable networks into a new public company. The new company would be well capitalized and positioned to acquire other cable networks if the ...
No single measurement can assess audio quality. Instead, engineers use a series of measurements to analyze various types of degradation that can reduce fidelity. Thus, when testing an analogue tape machine it is necessary to test for wow and flutter and tape speed variations over longer periods, as well as for distortion and noise.