Search results
Results from the WOW.Com Content Network
Display Data Channel (DDC) is a collection of protocols for digital communication between a computer display and a graphics adapter that enable the display to communicate its supported display modes to the adapter and that enable the computer host to adjust monitor parameters, such as brightness and contrast.
This is a self-clocking system, so no dedicated clock signal channel is necessary. [8]: §1.7.1 Unlike DVI and HDMI, which vary their transmission speed to the exact rate required for the specific video format, DisplayPort only operates at a few specific speeds; any excess bits in the transmission are filled with "stuffing symbols".
DisplayPort: DisplayPort (DP) was designed to replace VGA, DVI, and FPD-Link and standardized by VESA. [2] It is primarily used to connect a video source to a display device such as a computer monitor. It can also carry audio, USB, and other forms of data.
It refers to latency, or lag between when the signal is sent to the display and when the display starts to show that signal. This lag time has been measured as high as 68 ms, [ 1 ] or the equivalent of 3-4 frames on a 60 Hz display.
Note the DE-9 connector, cryptic mode switch, contrast and brightness controls at front, and the V-Size and V-Hold knobs at rear, which allow the control of the scaling and signal to CRT refresh rate synchronization respectively. Various computer display standards or display modes have been used in the history of the personal computer.
Most modern monitors will switch to a power-saving mode if no video-input signal is received. This allows modern operating systems to turn off a monitor after a specified period of inactivity. This also extends the monitor's service life. Some monitors will also switch themselves off after a time period on standby.
That is, if 4 lanes are being used, 4 bits are transmitted simultaneously, one on each lane. The link operates in either low power (LP) mode or high speed (HS) mode. In low power mode, the high-speed clock is disabled, and signal clocking information is embedded in the data. In this mode, the data rate is insufficient to drive a display, but is ...
The serial DCD pin can be used to accurately detect a PPS signal, as described in RFC 2783: [1] One convenient means to provide a PPS signal to a computer system is to connect that signal to a modem-control pin on a serial-line interface to the computer. The Data Carrier Detect (DCD) pin is frequently used for this purpose.