Search results
Results from the WOW.Com Content Network
Antennas can be classified in various ways, and various writers organize the different aspects of antennas with different priorities, depending on whether their text is most focused on specific frequency bands; or antenna size, construction, and placement feasibility; or explicating principles of radio theory and engineering that underlie ...
The CATR is used for microwave and millimeter wave frequencies where the far-field distance is large, such as with high-gain reflector antennas. The size of the range that is required can be much less than the size required for a full-size far-field anechoic chamber, although the cost of fabrication of the specially-designed CATR reflector can ...
The television broadcast bands are too wide in frequency to be covered by a single antenna, so the two options are separate antennas used for the VHF and UHF bands or a combination (combo) VHF/UHF antenna. [6] A VHF/UHF antenna combines two antennas feeding the same feedline mounted on the same support boom.
Very high frequency (VHF) is the ITU designation [1] for the range of radio frequency electromagnetic waves (radio waves) from 30 to 300 megahertz (MHz), with corresponding wavelengths of ten meters to one meter. Frequencies immediately below VHF are denoted high frequency (HF), and the next higher frequencies are known as ultra high frequency ...
The lowest frequencies used for radio communication are limited by the increasing size of transmitting antennas required. [6] The size of antenna required to radiate radio power efficiently increases in proportion to wavelength or inversely with frequency. Below about 10 kHz (a wavelength of 30 km), elevated wire antennas kilometers in diameter ...
As these antennas are made shorter (for a given frequency) their impedance becomes dominated by a series capacitive (negative) reactance; by adding an appropriate size "loading coil" – a series inductance with equal and opposite (positive) reactance – the antenna's capacitive reactance may be cancelled leaving only a pure resistance.
Using the antenna at around that frequency is advantageous in terms of feedpoint impedance (and thus standing wave ratio), so its length is determined by the intended wavelength (or frequency) of operation. [2] The most commonly used is the center-fed half-wave dipole which is just under a half-wavelength long.
Typical antenna sizes on C-band-capable systems range from 6 to 12 feet (1.8 to 3.5 meters) on consumer satellite dishes, although larger ones also can be used. For satellite communications, the microwave frequencies of the C band perform better under adverse weather conditions in comparison with the K u band (11.2–14.5 GHz ), microwave ...