enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Plywood - Wikipedia

   en.wikipedia.org/wiki/Plywood

   [citation needed] At 3 ⁄ 8 inch (9.5 mm) thick, mahogany three-ply "wiggle board" or "bendy board" come in 4 by 8 feet (1.2 m × 2.4 m) sheets with a very thin cross-grain central ply and two thicker exterior plies, either long grain on the sheet, or cross grain. Wiggle board is often glued together in two layers once it is formed into the ...

3. Board foot - Wikipedia

   en.wikipedia.org/wiki/Board_foot

   The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada. [1] It equals the volume of a board that is one foot (30.5 cm) in length, one foot in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters. Board foot can be abbreviated as FBM (for "foot, board measure"), BDFT ...

4. Lumber - Wikipedia

   en.wikipedia.org/wiki/Lumber

   In 1961, at a meeting in Scottsdale, Arizona, the Committee on Grade Simplification and Standardization agreed to what is now the current U.S. standard: in part, the dressed size of a 1-inch (nominal) board was fixed at 3 ⁄ 4 inch; while the dressed size of 2 inch (nominal) lumber was reduced from 1 + 5 ⁄ 8 inch to the current 1 + 1 ⁄ 2 ...

5. BS 1088 - Wikipedia

   en.wikipedia.org/wiki/BS_1088

   15 mm +.1/-0.9; 18 mm +.12/-0.98; 22 mm +.16/-1.08; 25 mm +1.8/-1.16 From the above we can assume that 6 mm material will arrive at thickness' between 6.04 mm and 5.35 mm. Face Veneer thickness -- For any three-ply construction, which applies to 3 and 4 mm material, each face veneer shall be not thinner than 1/8 of the total thickness of ...

6. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center. This spacing may be changed to 12 or 24 inches (300 or 610 mm) on center depending on the load and the limitations imposed by the type and thickness of the ...

7. Parallel-strand lumber - Wikipedia

   en.wikipedia.org/wiki/Parallel-strand_lumber

   The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...