Search results
Results from the WOW.Com Content Network
High grade and ultra high grade anthracite are harder than standard grade anthracite, and have a higher relative density. An example of a chemical formula for high-grade anthracite would be C 240 H 90 O 4 NS, [25] representing 94% carbon. [26] UHG anthracite typically has a minimum carbon content of 95%.
— "Values ranging from 21.3 to 21.5 gm/cm 3 at 20 °C have been reported for the density of annealed platinum; the best value being about 21.45 gm/cm 3 at 20 °C." 21.46 g/cm 3 — Rose, T. Kirke. The Precious Metals, Comprising Gold, Silver and Platinum .
The kilogram per cubic metre (symbol: kg·m −3, or kg/m 3) is the unit of density in the International System of Units (SI). It is defined by dividing the SI unit of mass, the kilogram, by the SI unit of volume, the cubic metre. [1]
Relative density or specific gravity of the coal depends on the rank of the coal and degree of mineral impurity. Knowledge of the density of each coal play is necessary to determine the properties of composites and blends. The density of the coal seam is necessary for conversion of resources into reserves.
For example when defining unit code m2 put SI2 here, and for m3 say SI3. This will scale, for example, km2 to 1000 × 1000 of the base unit, m , or scale mm3 to 0.001 × 0.001 × 0.001 of the base unit m .
Mathematically, density is defined as mass divided by volume: [1] =, where ρ is the density, m is the mass, and V is the volume. In some cases (for instance, in the United States oil and gas industry), density is loosely defined as its weight per unit volume , [ 2 ] although this is scientifically inaccurate – this quantity is more ...
Though bituminous coal varies in its chemical composition, a typical composition is about 84.4% carbon, 5.4% hydrogen, 6.7% oxygen, 1.7% nitrogen, and 1.8% sulfur, on a weight basis. [11] Its bank density (the density of a coal seam prior to breaking up during mining) is about 1346 kg/m 3 (84 lb/ft 3) while the bulk density of extracted coal is ...
S is specific surface, m 2 ·kg −1 d is the cylinder diameter, m ρ is the sample particle density, kg·m −3 ε is the volume porosity of the bed (dimensionless) δP is the pressure drop across the bed, Pa l is the cylinder length, m η is the air dynamic viscosity, Pa·s Q is the flowrate, m 3 ·s −1