Search results
Results from the WOW.Com Content Network
Grades may appear alone - for example, a lawnmower may require SAE 30. This single grade specification means that the oil must meet the SAE 30 requirements. But SAE also allows designating an oil with two viscosity grades, referred to as a multi-grade oil. For example, 10W-30 designates a common multi-grade oil. A 10W-30 oil must pass the SAE ...
In line with car manufacturers push towards these lower viscosities in search of better fuel economy, in April 2013 the Society of Automotive Engineers (SAE) introduced an SAE 16 viscosity rating, a break from its traditional "divisible by 10" numbering system for its high-temperature viscosity ratings that spanned from low-viscosity SAE 20 to ...
SAE J306 is a standard that defines the viscometric properties of automotive gear oils.It is maintained by SAE International. [1] Key parameters for this standard are the kinematic viscosity of the gear oil, the maximum temperature at which the oil has a viscosity of 150,000 cP, and a measure of its shear stability through the KRL test.
where U is the oil's kinematic viscosity at 40 °C (104 °F), Y is the oil's kinematic viscosity at 100 °C (212 °F), and L and H are the viscosities at 40 °C for two hypothetical oils of VI 0 and 100 respectively, having the same viscosity at 100 °C as the oil whose VI we are trying to determine.
For example, most modern gearboxes require a GL-4 oil, and separate differentials (where fitted) require a GL-5 oil. While they take the same form, the viscosity grades for gear oils are on a different scale than the viscosity grades for an engine oil. The viscometrics for gear oils are standardized in SAE J306.
The mini-rotary viscometer is a device used to measure the pumpability of an engine oil at low temperatures. [1] [2] Engine oils must meet viscometric standards including those determined by the MRV in order to be classifiable within SAE J300 viscosity grades. The requirement was added after the winters of 1980-81 and 1981-82 caused major ...
Common greases are in the range 1 through 3. Those with a NLGI No. of 000 to 1 are used in low viscosity applications. Examples include enclosed gear drives operating at low speeds and open gearing. Grades 0, 1 and 2 are used in highly loaded gearing. Grades 1 through 4 are often used in rolling contact bearings. Greases with a higher number ...
Extensional viscosity can be measured with various rheometers that apply extensional stress. Volume viscosity can be measured with an acoustic rheometer. Apparent viscosity is a calculation derived from tests performed on drilling fluid used in oil or gas well development. These calculations and tests help engineers develop and maintain the ...