Search results
Results from the WOW.Com Content Network
Simple CVTs combining a centrifugal drive pulley with a spring-loaded driven pulley often use belt tension to effect the conforming adjustments in the driven pulley. [3] The V-belt needs to be very stiff in the pulley's axial direction to make only short radial movements while sliding in and out of the pulleys. The radial thickness of the belt ...
A chainsaw's clutch. The chain wraps around a sprocket behind the clutch that turns with the outer drum. The input of the clutch is connected to the engine crankshaft while the output may drive a shaft, chain, or belt. As engine revolutions per minute increase, weighted arms in the clutch swing outward and force the clutch to engage. The most ...
Serpentine belt (foreground) and dual vee belt (background) on a bus engine Belt tensioner providing pressure against the back of a serpentine belt in an automobile engine. A serpentine belt (or drive belt [1]) is a single, continuous belt used to drive multiple peripheral devices in an automotive engine, such as an alternator, power steering pump, water pump, air conditioning compressor, air ...
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
The open belt drive has parallel shafts rotating in the same direction, whereas the cross-belt drive also bears parallel shafts but rotate in opposite direction. The former is far more common, and the latter not appropriate for timing and standard V-belts unless there is a twist between each pulley so that the pulleys only contact the same belt ...
The standard Fluid Drive configuration consisted of the fluid coupling and a manual transmission and clutch in tandem. If the Fluid Drive was mated to a manual transmission, the driver still needed to use the clutch to shift between any of the gears. The presence of Fluid Drive, however, prevented the driver stalling when taking off from a dead ...
A propeller speed reduction unit is a gearbox or a belt and pulley device used to reduce the output revolutions per minute (rpm) from the higher input rpm of the powerplant. [1] This allows the use of small displacement internal combustion engines to turn aircraft propellers within an efficient speed range.
The Comet J11 was manufactured from 1954 to 1955. Engine: Villiers Mk 4F (98cc) (47mm x 57mm), Carburetor was a Villiers Type 6/0; Transmission: Two speed with clutch. Frame: Single down tube; Suspension: Front was lightweight telescopic fork, plastic gaiters. Rear was a plunger-type. Brakes: 4" front, 5" rear; Drive: Chain and sprocket