Search results
Results from the WOW.Com Content Network
The ultimate tensile strength of a material is an intensive property; therefore its value does not depend on the size of the test specimen.However, depending on the material, it may be dependent on other factors, such as the preparation of the specimen, the presence or otherwise of surface defects, and the temperature of the test environment and material.
Yield strength (0.2% offset, ksi) Tensile strength (ksi) Elongation in 2 inches (percent) Hardness (Brinell scale) Comments Copper (ASTM B1, B2, B3, B152, B124, R133) Cu 99.9 Annealed 10 32 45 42 Electrical equipment, roofing, screens Cold-drawn 40 45 15 90 Cold-rolled 40 46 5 100 Gilding metal (ASTM B36) Cu 95.0, Zn 5.0 Cold-rolled 50 56 5 114
Bronze is an alloy consisting primarily of copper, commonly with about 12–12.5% tin and often with the addition of other metals (including aluminium, manganese, nickel, or zinc) and sometimes non-metals, such as phosphorus, or metalloids, such as arsenic or silicon.
Steel for rail use: Minimum Yield Case: H: High Tensile Strength Flat products: Minimum Yield Case: If followed by T then the given mechanical property is minimum tensile strength D: Flat Products for Cold Forming: Followed by C, D or X and two numbers characterising steel T: Tinmill Products: Nominal Yield Case: M: Electrical Steel: Number ...
Typical values of the limit for steels are one half the ultimate tensile strength, to a maximum of 290 MPa (42 ksi). For iron, aluminium, and copper alloys, S e {\displaystyle S_{e}} is typically 0.4 times the ultimate tensile strength.
The typical test uses a 10 mm (0.39 in) diameter steel ball as an indenter with a 3,000 kgf (29.42 kN; 6,614 lbf) force. For softer materials, a smaller force is used; for harder materials, a tungsten carbide ball is substituted for the steel ball. The indentation is measured and hardness calculated as:
High-strength, low-temperature. For aluminium-to-aluminium and aluminium-to-copper. 78: 22: Ag 72 Zn 28: 710/730 [8] – Ag72Zn. Ammonia-resistant. For joining ferrous and non-ferrous metals (steel, copper, brass...). Good flow properties. With stainless steel in humid environments risk of interfacial corrosion.
Electrical steel is an iron alloy which may have from zero to 6.5% silicon (Si:5Fe). Commercial alloys usually have silicon content up to 3.2% (higher concentrations result in brittleness during cold rolling). Manganese and aluminum can be added up to 0.5%. [1]