Search results
Results from the WOW.Com Content Network
The gusset plate is usually painted to match nearby steel and fixtures and to give it an extra layer of protection. [2] Occasionally gusset plates are made from copper or aluminum, but only with small structures that do not require much support. The copper and aluminum gusset plates also provide a more attractive finish for exposed structures. [2]
Truss plates are light gauge metal plates used to connect prefabricated light frame wood trusses. They are produced by punching light gauge galvanized steel to create teeth on one side. The teeth are embedded in and hold the wooden frame components to the plate and each other. Nail plates are used to connect timber of the same thickness in the ...
A fishplate, splice bar or joint bar is a metal connecting plate used to bolt the ends of two rails into a continuous track. The name is derived from fish, [1] a wooden reinforcement of a "built-up" ship's mast that helped round out its desired profile. [2] The top and bottom faces taper inwards along their short dimensions to create an even ...
A Howe truss is a truss bridge consisting of chords, verticals, and diagonals whose vertical members are in tension and whose diagonal members are in compression. The Howe truss was invented by William Howe in 1840, and was widely used as a bridge in the mid to late 1800s.
A surface plate is a solid, flat plate used as the main horizontal reference plane for precision inspection, marking out (layout), and tooling setup. [1] The surface plate is often used as the baseline for all measurements to a workpiece, therefore one primary surface is finished extremely flat with tolerances below 11.5 μm or 0.0115 mm per ...
Splice or butt connectors (primarily insulation displacement connectors) that permanently join two lengths of wire or cable. In computing, electrical connectors are considered a physical interface and constitute part of the physical layer in the OSI model of networking.
Overview. In a plate girder bridge, the plate girders are typically I-beams made up from separate structural steel plates (rather than rolled as a single cross-section), which are welded or, in older bridges, bolted or riveted together to form the vertical web and horizontal flanges of the beam. In some cases, the plate girders may be formed in ...
Gusset plates, usually triangular, are often used to join metal plates and can be seen in many metal framed constructions. Expanding folders or accordion folders also employ gussets to allow for expansion when containing more than just a few sheets of paper. The gusset is also a charge in heraldry, as is the gyron (an Old French word for gusset).