Search results
Results from the WOW.Com Content Network
The axle load of a wheeled vehicle is the total weight bearing on the roadway for all wheels connected to a given axle.Axle load is an important design consideration in the engineering of roadways and railways, as both are designed to tolerate a maximum weight-per-axle (axle load); exceeding the maximum rated axle load will cause damage to the roadway or railway tracks.
A tandem axle is defined as two or more consecutive axles whose centers are spaced more than 40 inches (102 cm) but not more than 96 inches (244 cm) apart. [10] Axles spaced less than 40 inches (102 cm) apart are considered a single axle. [11] In effect, the formula reduces the legal weight limit for shorter trucks with fewer axles (see table below
Download as PDF; Printable version; In other projects Appearance. move to sidebar hide. From Wikipedia, the free encyclopedia. Redirect page. Redirect to: Axle load;
When evaluating the series of tests, it was found that there is a connection between the thickness of the pavement, the number of load transfers and the axle load, and that these have a direct effect on the service life and condition of a road. The service life of the road is thereby reduced with approximately the fourth power of the axle load. [1]
This can give information about the distribution of axles. For example, provide manufacturers the chassis configuration 8×4×4 to show that the vehicle has two steered front axles and two driven rear axles, compared to the chassis configuration 8×4/4 where the vehicle has one steered front axle, one steered rear axle (the fore axle) and two ...
A true semi-floating axle assembly places no side loads on the axle housing tubes or axle shafts. Axles that are pressed into ball or tapered roller bearings, which are in turn retained in the axle housings with flanges, bolts, and nuts do not "float" and place axial loads on the bearings, housings, and only a short section of the shaft itself ...
The axle load will not usually be the sum of the two wheel loads because the line of action of the cross-balancing will be different in each wheel. [26] With the locomotive's static weight known the amount of overbalance which may be put into each wheel to partially balance the reciprocating parts is calculated. [ 27 ]
Weigh-in-motion is a technology that can be used for various private and public purposes (i.e. applications) related to the weights and axle loads of road and rail vehicles. WIM systems are installed on the road or rail track or on a vehicle and measure, store and provide data from the traffic flow and/or the specific vehicle.