Ad
related to: clock signal electronics corporation
Search results
Results from the WOW.Com Content Network
Clock signal and legend. In electronics and especially synchronous digital circuits, a clock signal (historically also known as logic beat) [1] is an electronic logic signal (voltage or current) which oscillates between a high and a low state at a constant frequency and is used like a metronome to synchronize actions of digital circuits.
A clock generator is an electronic oscillator that produces a clock signal for use in synchronizing a circuit's operation. The output clock signal can range from a simple symmetrical square wave to more complex arrangements. The basic parts that all clock generators share are a resonant circuit and an amplifier.
Clock skew (sometimes called timing skew) is a phenomenon in synchronous digital circuit systems (such as computer systems) in which the same sourced clock signal arrives at different components at different times due to gate or, in more advanced semiconductor technology, wire signal propagation delay.
Clock recovery addresses this problem by embedding clock information into the data stream, allowing the transmitter's clock timing to be determined. This normally takes the form of short signals inserted into the data that can be easily seen and then used in a phase-locked loop or similar adjustable oscillator to produce a local clock signal ...
In this image, the lower signal is the clock and the upper signal is the data. Data is recognized by the circuit at the positive edge of the clock. There are two time intervals illustrated in this image. One is the setup time, and the other is the timing margin. The setup time is illustrated in red in this image; the timing margin is ...
From this definition it is more obvious that the XOR of Data and Strobe will yield a clock signal. Also, it specifies the simplest means of generating the Strobe signal for a given Data stream. Data strobe encoding originated in IEEE 1355 Standard and is used on the signal lines in SpaceWire and the IEEE 1394 (also known as FireWire 400 ) system.
Watchdog timers are implemented in various ways. Some electronic WDTs (e.g., Analog Devices MAX6324) use linear timing circuits that operate without a digital clock signal. Other electronic WDTs, and software WDTs, typically employ digital counters as timers and rely on a clock signal for proper operation.
The ϕ1 and ϕ3 clocks need to be non-overlapping, as do the ϕ2 and ϕ4 clocks. Considering the 1 gate, during the ϕ1 clock high time (also known as the precharge time), the output C precharges up to V(ϕ1)−V th, where V th represents the threshold of the precharge transistor.
Ad
related to: clock signal electronics corporation